8 material differences · fewer than 12
Tractor oneDeutz-Fahr DX 2301980–1982No measured PTO figureTractor twoSchlüter Profi Trac 2000 VL1976No measured PTO figure
Which should you choose?
We will not advise between these two machines, because they were not built in overlapping years (1980–1982; 1976–1976). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
8 material differences · 5 fields identical or within 5%, which is not counted as material
| Field | DX 230 | Profi Trac 2000 VL | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 196.3 hp | 197 hp | — |
| Engine declared | KHD BF6L 413 FR | MAN D 2565 ME | differs |
| Displacement declared | 9.57 L | 9.51 L | — |
| Maximum torque declared | 553 lb·ft · 750 N·m | 542 lb·ft · 735 N·m | — |
| Transmission | |||
| Top speed declared | 15.5–18.6 mph · 25–30 km/h | 19.8 mph · 31.9 km/h | differs |
| Clutch declared | — | Schlueter Hydromatik | — |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Open centre | — | — |
| Pump flow declared | 21.4 gpm · 81 L/min | 9.0 gpm · 34.0 L/min | +138% DX 230 |
| Rear PTO speeds declared | 923 rpm | 1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 20,393 lb · 9,250 kg | 20,944 lb · 9,500 kg | — |
| Maximum permissible mass declared | 26,455 lb · 12,000 kg | — | — |
| Wheelbase declared | 118.6 in · 3,012 mm | 112.2 in · 2,850 mm | +6% DX 230 |
| Length declared | 213.7 in · 5,427 mm | 236.2 in · 6,000 mm | +11% Profi Trac 2000 VL |
| Width declared | 98.4 in · 2,500 mm | 96.5 in · 2,450 mm | — |
| Ground clearance declared | 20.7 in · 525 mm | 18.3 in · 465 mm | +13% DX 230 |
| Turning radius, braked declared | — | 15.1 ft · 4.60 m | — |
| Fuel tank declared | 422.7 qt · 400 L | 470.2 qt · 445 L | +11% Profi Trac 2000 VL |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Deutz-Fahr DX 230 sources
- Source: Traktorenlexikon, “Deutz-Fahr DX 230”
Schlüter Profi Trac 2000 VL sources
- Source: Traktorenlexikon, “Schlüter Profi Trac 2000 VL”