14 material differences

Tractor oneDeutz-Fahr DX 1451980–1983No measured PTO figureTractor twoFord 86301989–1994No measured PTO figure

Which should you choose?

We will not advise between these two machines, because their unladen weight differs by more than 25% (63%); the drive differs (Two-wheel or four-wheel drive; 4WD); they were not built in overlapping years (1980–1983; 1989–1994). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.

Field by field

14 material differences · 2 fields identical or within 5%, which is not counted as material

Deutz-Fahr DX 145 and Ford 8630, field by field
FieldDX 1458630Gap
Engine
Engine power, claimed claimed130 hp130.2 hp—
Engine declaredKHD BF6L 913Ford 401differs
Displacement declared6.13 L6.57 L+7% 8630
Maximum torque declared371 lb·ft · 503 N·m347 lb·ft · 471 N·m+7% DX 145
Transmission
Top speed declared15.5–18.6 mph · 25–30 km/h18.6 mph · 30 km/hdiffers
Clutch declaredpedal operated dry single clutchelectro-hydraulically operated FUNK multi-disc clutchdiffers
Hydraulics & hitch
Hydraulic centre declaredOpen centre——
Pump flow declared14.7 gpm · 55.7 L/min28.3 gpm · 107.1 L/min+92% 8630
Pressure declared3,191 psi · 220 bar2,799 psi · 193 bar+14% DX 145
Rear PTO speeds declared540 rpm / 1000 rpm540/1000 rpmdiffers
Weight & dimensions
Unladen weight declared11,266 lb · 5,110 kg18,400 lb · 8,346 kg+63% 8630
Maximum permissible mass declared16,976 lb · 7,700 kg23,091 lb · 10,474 kg+36% 8630
Wheelbase declared105.9 in · 2,690 mm105.0 in · 2,667 mm—
Length declared177.2 in · 4,500 mm206.4 in · 5,243 mm+17% 8630
Width declared93.3 in · 2,370 mm83.6 in · 2,123 mm+12% DX 145
Ground clearance declared22.8 in · 580 mm15.5 in · 394 mm+47% DX 145
Fuel tank declared132.1 qt · 125 L232.5–401.5 qt · 220.0–380.0 Ldiffers

Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.

Deutz-Fahr DX 145 sources

Source
  • Source: Traktorenlexikon, “Deutz-Fahr DX 145”
  • Source: Traktorenlexikon, “Deutz-Fahr DX 160”

Ford 8630 sources

Source
  • Source: Traktorenlexikon, “Ford 8630”