11 material differences · fewer than 12
Tractor oneDeutz-Fahr D 7207 (C)1980–1984No measured PTO figureTractor twoFendt Farmer 270 P/PA1987–1996No measured PTO figure
Which should you choose?
We will not advise between these two machines, because they were not built in overlapping years (1980–1984; 1987–1996). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
11 material differences · 4 fields identical or within 5%, which is not counted as material
| Field | D 7207 (C) | Farmer 270 P/PA | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 68 hp | 68 hp | — |
| Engine declared | KHD F4L 912 | KHD F4L 912 | — |
| Displacement declared | 3.77 L | 3.77 L | — |
| Maximum torque declared | 181 lb·ft · 245 N·m | 180 lb·ft · 244 N·m | — |
| Transmission | |||
| Top speed declared | 15.5–18.6 mph · 25–30 km/h | 18.6–24.9 mph · 30–40 km/h | differs |
| Clutch declared | Independent dry Fichtel & Sachs double clutch | — | — |
| Hydraulics & hitch | |||
| Pump flow declared | 10.5 gpm · 39.6 L/min | 17.4 gpm · 66.0 L/min | +67% Farmer 270 P/PA |
| Rear PTO speeds declared | 540 rpm / 1000 rpm | 540/750 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 6,437 lb · 2,920 kg | 5,512 lb · 2,500 kg | +17% D 7207 (C) |
| Maximum permissible mass declared | 11,023 lb · 5,000 kg | 8,818 lb · 4,000 kg | +25% D 7207 (C) |
| Wheelbase declared | 95.0 in · 2,414 mm | 85.8 in · 2,180 mm | +11% D 7207 (C) |
| Length declared | 158.3 in · 4,020 mm | 143.5 in · 3,646 mm | +10% D 7207 (C) |
| Width declared | 78.3 in · 1,990 mm | 65.6 in · 1,666 mm | +19% D 7207 (C) |
| Ground clearance declared | 22.8 in · 580 mm | 10.1 in · 257 mm | +126% D 7207 (C) |
| Turning radius, braked declared | 12.5 ft · 3.81 m | 10.8 ft · 3.30 m | +15% D 7207 (C) |
| Fuel tank declared | 95.1–97.2 qt · 90–92 L | 63.4 qt · 60 L | differs |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Deutz-Fahr D 7207 (C) sources
- Source: Traktorenlexikon, “Deutz-Fahr D 7207”
- Source: Traktorenlexikon, “Deutz D 6006”
Fendt Farmer 270 P/PA sources
- Source: Traktorenlexikon, “Fendt Farmer 270 P/PA”
- Source: Traktorenlexikon, “Deutz D 6006”