9 material differences · fewer than 12
Tractor oneDeutz-Fahr D 7007 (C)1982–1984No measured PTO figureTractor twoFiat 70-66 S (DT)1992–1996No measured PTO figure
Which should you choose?
We will not advise between these two machines, because they were not built in overlapping years (1982–1984; 1992–1996). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
9 material differences · 6 fields identical or within 5%, which is not counted as material
| Field | D 7007 (C) | 70-66 S (DT) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 68 hp | 68.1 hp | — |
| Engine declared | KHD F4L 912 | Fiat 8045.06 | differs |
| Displacement declared | 3.77 L | 3.61 L | — |
| Maximum torque declared | 181 lb·ft · 245 N·m | 165 lb·ft · 224 N·m | +9% D 7007 (C) |
| Transmission | |||
| Top speed declared | 15.5–18.6 mph · 25–30 km/h | 18.6–24.9 mph · 30–40 km/h | differs |
| Clutch declared | Independent dry double clutch | — | — |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Open centre | — | — |
| Pump flow declared | — | 9.1 gpm · 34.5 L/min | — |
| Three-point lift, at the coupling points declared | 5,732 lb · 2,600 kg | 7,859 lb · 3,565 kg | +37% 70-66 S (DT) |
| Rear PTO speeds declared | 540 rpm / 1000 rpm | 540 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 6,305 lb · 2,860 kg | 6,173 lb · 2,800 kg | — |
| Maximum permissible mass declared | 11,023 lb · 5,000 kg | 10,141 lb · 4,600 kg | +9% D 7007 (C) |
| Wheelbase declared | 85.4 in · 2,170 mm | 90.9 in · 2,310 mm | +6% 70-66 S (DT) |
| Length declared | 148.0 in · 3,760 mm | 154.3 in · 3,920 mm | — |
| Width declared | 78.3 in · 1,990 mm | 78.0 in · 1,980 mm | — |
| Ground clearance declared | 21.7 in · 550 mm | 15.7 in · 400 mm | +38% D 7007 (C) |
| Turning radius, braked declared | 11.5 ft · 3.50 m | 11.3 ft · 3.45 m | — |
| Fuel tank declared | 97.2 qt · 92 L | 77.1 qt · 73.0 L | +26% D 7007 (C) |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Deutz-Fahr D 7007 (C) sources
- Source: Traktorenlexikon, “Deutz-Fahr D 7007”
- Source: Traktorenlexikon, “Deutz D 6006”
Fiat 70-66 S (DT) sources
- Source: Traktorenlexikon, “Fiatagri 70-66S/70-66 DTS”
- Source: Traktorenlexikon, “Fiatagri 65-66S/65-66 DTS”