11 material differences · fewer than 12

Tractor oneDeutz-Fahr D 6807 (C)1981–1982No measured PTO figureTractor twoFiat PRIMO 60-66 DT/Turbo1988–1992No measured PTO figure

Which should you choose?

We will not advise between these two machines, because the drive differs (Two-wheel or four-wheel drive; 4WD); they were not built in overlapping years (1981–1982; 1988–1992). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.

Field by field

11 material differences · 4 fields identical or within 5%, which is not counted as material

Deutz-Fahr D 6807 (C) and Fiat PRIMO 60-66 DT/Turbo, field by field
FieldD 6807 (C)PRIMO 60-66 DT/TurboGap
Engine
Engine power, claimed claimed66 hp65.2 hp—
Engine declaredKHD F4L 912FIAT-IVECO 8035.05 Turbodiffers
Displacement declared3.77 L2.93 L+29% D 6807 (C)
Maximum torque declared176 lb·ft · 238 N·m147 lb·ft · 199 N·m+20% D 6807 (C)
Transmission
Top speed declared15.5–18.6 mph · 25–30 km/h18.6–24.9 mph · 30–40 km/hdiffers
Clutch declared—Dry Valeo or LuK double clutch—
Hydraulics & hitch
Hydraulic centre declaredOpen centre——
Pump flow declared11.1 gpm · 42.0 L/min8.7 gpm · 32.8 L/min+28% D 6807 (C)
Rear PTO speeds declared540 rpm / 1000 rpm540/1000 rpmdiffers
Weight & dimensions
Unladen weight declared6,305 lb · 2,860 kg6,437 lb · 2,920 kg—
Maximum permissible mass declared11,023 lb · 5,000 kg9,259 lb · 4,200 kg+19% D 6807 (C)
Wheelbase declared85.4 in · 2,170 mm84.6 in · 2,148 mm—
Length declared148.0 in · 3,760 mm143.7 in · 3,650 mm—
Width declared78.3 in · 1,990 mm75.2–92.5 in · 1,910–2,350 mmdiffers
Ground clearance declared18.9 in · 480 mm15.0 in · 380 mm+26% D 6807 (C)
Turning radius, braked declared11.9 ft · 3.62 m13.5 ft · 4.10 m+13% PRIMO 60-66 DT/Turbo
Fuel tank declared97.2 qt · 92 L77.1 qt · 73.0 L+26% D 6807 (C)

Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.

Deutz-Fahr D 6807 (C) sources

Source
  • Source: Traktorenlexikon, “Deutz-Fahr D 6807”
  • Source: Traktorenlexikon, “Deutz D 6006”

Fiat PRIMO 60-66 DT/Turbo sources

Source
  • Source: Traktorenlexikon, “Fiat 60-66 Turbo/60-66 DT Turbo”