Deutz-Fahr AgroXtra 3.57 or ZETOR 6211/6245?

Which should you choose?

The data can’t decide this. Power at the PTO shaft cannot be compared: the AgroXtra 3.57 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 6211/6245 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.

  • The ZETOR 6211/6245 suits loader and hydraulic implement work better on this data: 50% (18.9 L/min / 5.0 gpm) more hydraulic flow.
  • The Deutz-Fahr AgroXtra 3.57 suits road haulage better on this data: 20% (5.0 km/h / 3.1 mph) more top speed.

Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.

What decides it, question by question?

Buyer questions for Deutz-Fahr AgroXtra 3.57 and ZETOR 6211/6245, with the call on each
QuestionAgroXtra 3.576211/6245Call
Which puts more power through the PTO shaft?43.9 kW (58.9 hp)Traktorenlexikon, “Deutz-Fahr AgroXtra 3.57”43.4 kW (58.2 hp)Traktorenlexikon, “Zetor 6211”Not comparableNot comparable on power at the PTO shaft: the AgroXtra 3.57 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 6211/6245 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
Which turns a litre of fuel into more work at the shaft?——No figureNo call on fuel efficiency at the shaft: no figure on record for the AgroXtra 3.57 and the 6211/6245.
Which pulls harder at the drawbar?——No figureNo call on drawbar power: no figure on record for the AgroXtra 3.57 and the 6211/6245.
Which pumps more oil for implements?38.0 L/min (10.0 gpm)Traktorenlexikon, “Deutz-Fahr AgroXtra 3.57”56.9 L/min (15.0 gpm)Traktorenlexikon, “Zetor 6211”AheadThe ZETOR 6211/6245 has 50% more hydraulic flow (18.9 L/min / 5.0 gpm) than the Deutz-Fahr AgroXtra 3.57 (both pump flow, as stated by the source).
Which lifts more on the three-point hitch?2,400 kg (5,291 lb)Traktorenlexikon, “Deutz-Fahr AgroXtra 3.57”—No figureNo call on three-point lift: no figure on record for the 6211/6245.
Which is heavier, for traction?3,290 kg (7,253 lb)Traktorenlexikon, “Deutz-Fahr AgroXtra 3.57”2,960 kg (6,526 lb)Traktorenlexikon, “Zetor 6211”Ahead (a fact, not an advantage)The Deutz-Fahr AgroXtra 3.57 is 11% heavier (330 kg / 728 lb) than the ZETOR 6211/6245 (both unladen weight, as stated by the source).
Which may carry more ballast and load?4,500 kg (9,921 lb)Traktorenlexikon, “Deutz-Fahr AgroXtra 3.57”—No figureNo call on maximum permissible mass: no figure on record for the 6211/6245.
Which has the wider choice of gears?16Traktorenlexikon, “Deutz-Fahr AgroXtra 3.57”10 to 20Traktorenlexikon, “Zetor 6211”EvenEven on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap.
Which offers a creeper range?——No figureNo call on a creeper range: not stated for the AgroXtra 3.57 and the 6211/6245.
Which is faster on the road?30 km/h (18.6 mph) to 40 km/h (24.9 mph)Traktorenlexikon, “Deutz-Fahr AgroXtra 3.57”25 km/h (15.5 mph)Traktorenlexikon, “Zetor 6211”AheadThe Deutz-Fahr AgroXtra 3.57 has 20% more top speed (5.0 km/h / 3.1 mph) than the ZETOR 6211/6245 (both top speed forward, as stated by the source).
Which offers more PTO speeds?540/1000/750 rpmTraktorenlexikon, “Deutz-Fahr AgroXtra 3.57”540/1000 rpmTraktorenlexikon, “Zetor 6211”AheadThe Deutz-Fahr AgroXtra 3.57 offers 750 rpm at the PTO, which the ZETOR 6211/6245 does not (as stated by the sources).
Which PTO runs independently of the ground drive?independentTraktorenlexikon, “Deutz-Fahr AgroXtra 3.57”independentTraktorenlexikon, “Zetor 6211”EvenEven on PTO independence: every PTO is independent.
Which drives on both axles?4WDTraktorenlexikon, “Deutz-Fahr AgroXtra 3.57”Two-wheel or four-wheel driveTraktorenlexikon, “Zetor 6211”EvenEven on drive: every machine is available with four-wheel drive.
Which is newer, and what about parts?1991–19961984–1993Ahead (a fact, not an advantage)The Deutz-Fahr AgroXtra 3.57 is newer: production began 7 years later. We hold no parts-availability data, so there is no call on parts.

What does this mean in plain words?

  • The ZETOR 6211/6245 has 50% more hydraulic flow (18.9 L/min / 5.0 gpm) than the Deutz-Fahr AgroXtra 3.57 (both pump flow, as stated by the source).
  • The Deutz-Fahr AgroXtra 3.57 is 11% heavier (330 kg / 728 lb) than the ZETOR 6211/6245 (both unladen weight, as stated by the source).
  • The Deutz-Fahr AgroXtra 3.57 has 20% more top speed (5.0 km/h / 3.1 mph) than the ZETOR 6211/6245 (both top speed forward, as stated by the source).
  • The Deutz-Fahr AgroXtra 3.57 offers 750 rpm at the PTO, which the ZETOR 6211/6245 does not (as stated by the sources).
  • The Deutz-Fahr AgroXtra 3.57 is newer: production began 7 years later. We hold no parts-availability data, so there is no call on parts.
  • Even on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap.
  • Even on PTO independence: every PTO is independent.
  • Even on drive: every machine is available with four-wheel drive.
  • Not comparable on power at the PTO shaft: the AgroXtra 3.57 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 6211/6245 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
  • No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, three-point lift, maximum permissible mass and a creeper range.

← Every figure for both machines, side by side, with sources