7 material differences · fewer than 12
Tractor oneDeutz-Fahr Agrotron K 4302008–2013No measured PTO figureTractor twoNew Holland T 50702009–2012No measured PTO figure
Which should you choose?
We will not advise between these two machines, because the drive differs (4WD; 4WD / 2WD). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
7 material differences · 5 fields identical or within 5%, which is not counted as material
| Field | Agrotron K 430 | T 5070 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 110 hp | 111.4 hp | — |
| Engine declared | — | IVECO-NEF F4CE 9484 | — |
| Displacement declared | — | 4.49 L | — |
| Maximum torque declared | 363 lb·ft · 492 N·m | 347 lb·ft · 471 N·m | — |
| Transmission | |||
| Top speed declared | 24.9–31.1 mph · 40–50 km/h | 18.6–24.9 mph · 30–40 km/h | differs |
| Clutch declared | Electro-hydraulic comfort clutch running in an oil bath | electrohydraulically operated wet multi-plate clutch | differs |
| Hydraulics & hitch | |||
| Pump flow declared | — | 17.2 gpm · 65.0 L/min | — |
| Pressure declared | — | 3,336 psi · 230 bar | — |
| Rear PTO speeds declared | 540/540E/1000/1000E rpm | 540/540E/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 9,789 lb · 4,440 kg | 9,480 lb · 4,300 kg | — |
| Maximum permissible mass declared | 17,637 lb · 8,000 kg | 16,314 lb · 7,400 kg | +8% Agrotron K 430 |
| Wheelbase declared | 95.2 in · 2,419 mm | 92.5 in · 2,350 mm | — |
| Length declared | 163.0 in · 4,139 mm | 162.2 in · 4,120 mm | — |
| Width declared | 95.7 in · 2,430 mm | 84.2 in · 2,138 mm | +14% Agrotron K 430 |
| Ground clearance declared | 15.7 in · 400 mm | 19.2 in · 488 mm | +22% T 5070 |
| Turning radius, braked declared | 15.3 ft · 4.65 m | — | — |
| Fuel tank declared | 190.2 qt · 180 L | 176.5 qt · 167.0 L | +8% Agrotron K 430 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Deutz-Fahr Agrotron K 430 sources
- Source: Traktorenlexikon, “Deutz-Fahr Agrotron K 430”
New Holland T 5070 sources
- Source: Traktorenlexikon, “New Holland T 5070”
- Source: Traktorenlexikon, “New Holland T5060”