8 material differences · fewer than 12

Tractor oneDeutz-Fahr Agrotron K 110 (Profiline)2005–2008No measured PTO figureTractor twoFendt Farmer 3101993–2001No measured PTO figure

Which should you choose?

We will not advise between these two machines, because the drive differs (4WD; 4WD / 2WD); they were not built in overlapping years (2005–2008; 1993–2001). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.

Field by field

8 material differences · 5 fields identical or within 5%, which is not counted as material

Deutz-Fahr Agrotron K 110 (Profiline) and Fendt Farmer 310, field by field
FieldAgrotron K 110 (Profiline)Farmer 310Gap
Engine
Engine power, claimed claimed102.6 hp103 hp—
Engine declaredDeutz BF6M 2012 CMWM TD 226. B-4differs
Displacement declared6.06 L4.16 L+46% Agrotron K 110 (Profiline)
Maximum torque declared308 lb·ft · 418 N·m309 lb·ft · 419 N·m—
Transmission
Top speed declared24.9–31.1 mph · 40–50 km/h24.9 mph · 40 km/hdiffers
Hydraulics & hitch
Hydraulic centre declaredOpen centre——
Pump flow declared—19.8 gpm · 75.0 L/min—
Rear PTO speeds declared540 rpm / 1000 rpm540/750/1000 rpmdiffers
Weight & dimensions
Unladen weight declared10,692 lb · 4,850 kg10,803 lb · 4,900 kg—
Maximum permissible mass declared17,637 lb · 8,000 kg18,739 lb · 8,500 kg+6% Farmer 310
Wheelbase declared104.2 in · 2,647 mm91.9 in · 2,333 mm+13% Agrotron K 110 (Profiline)
Length declared171.9 in · 4,367 mm164.6 in · 4,180 mm—
Width declared88.8 in · 2,256 mm89.8 in · 2,280 mm—
Ground clearance declared19.1 in · 485 mm21.1 in · 536 mm+11% Farmer 310
Turning radius, braked declared—13.1 ft · 4.00 m—
Fuel tank declared190.2 qt · 180 L142.7 qt · 135 L+33% Agrotron K 110 (Profiline)

Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.

Deutz-Fahr Agrotron K 110 (Profiline) sources

Source
  • Source: Traktorenlexikon, “Deutz-Fahr Agrotron K 110”

Fendt Farmer 310 sources

Source
  • Source: Traktorenlexikon, “Fendt Farmer 310”
  • Source: Traktorenlexikon, “Fendt Farmer 308”