Deutz-Fahr Agrotron 80 or New Holland TL 80 (A)?

Which should you choose?

The data can’t decide this. Power at the PTO shaft cannot be compared: the Agrotron 80 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the TL 80 (A) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.

  • The Deutz-Fahr Agrotron 80 suits loader and hydraulic implement work better on this data: 86% (2,870 kg / 6,327 lb) more three-point lift.
  • The Deutz-Fahr Agrotron 80 suits road haulage better on this data: 25% (1,300 kg / 2,866 lb) more maximum permissible mass.

Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.

What decides it, question by question?

Buyer questions for Deutz-Fahr Agrotron 80 and New Holland TL 80 (A), with the call on each
QuestionAgrotron 80TL 80 (A)Call
Which puts more power through the PTO shaft?55.2 kW (74.0 hp)Traktorenlexikon, “Deutz-Fahr Agrotron 80”55.2 kW (74.0 hp)Traktorenlexikon, “New Holland TL80”Not comparableNot comparable on power at the PTO shaft: the Agrotron 80 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the TL 80 (A) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
Which turns a litre of fuel into more work at the shaft?——No figureNo call on fuel efficiency at the shaft: no figure on record for the Agrotron 80 and the TL 80 (A).
Which pulls harder at the drawbar?——No figureNo call on drawbar power: no figure on record for the Agrotron 80 and the TL 80 (A).
Which pumps more oil for implements?66.0 L/min (17.4 gpm)Traktorenlexikon, “Deutz-Fahr Agrotron 80”60.0 L/min (15.9 gpm)Traktorenlexikon, “New Holland TL80”EvenEven on hydraulic flow (both pump flow, as stated by the source): the difference is under the 10% threshold, too small to call.
Which lifts more on the three-point hitch?6,220 kg (13,713 lb)Traktorenlexikon, “Deutz-Fahr Agrotron 80”3,350 kg (7,385 lb)Traktorenlexikon, “New Holland TL80”AheadThe Deutz-Fahr Agrotron 80 has 86% more lift (2,870 kg / 6,327 lb) than the New Holland TL 80 (A) (both lift at the hitch ends, as stated by the source).
Which is heavier, for traction?3,970 kg (8,752 lb)Traktorenlexikon, “Deutz-Fahr Agrotron 80”4,150 kg (9,149 lb)Traktorenlexikon, “New Holland TL80”EvenEven on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call.
Which may carry more ballast and load?6,500 kg (14,330 lb)Traktorenlexikon, “Deutz-Fahr Agrotron 80”5,200 kg (11,464 lb)Traktorenlexikon, “New Holland TL80”AheadThe Deutz-Fahr Agrotron 80 has 25% higher maximum permissible mass (1,300 kg / 2,866 lb) than the New Holland TL 80 (A) (both maximum permissible mass, as stated by the source).
Which has the wider choice of gears?21 to 24Traktorenlexikon, “Deutz-Fahr Agrotron 80”20 to 24Traktorenlexikon, “New Holland TL80”EvenEven on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap.
Which offers a creeper range?—YesTraktorenlexikon, “New Holland TL80”No figureNo call on a creeper range: not stated for the Agrotron 80.
Which is faster on the road?30 km/h (18.6 mph) to 40 km/h (24.9 mph)Traktorenlexikon, “Deutz-Fahr Agrotron 80”30 km/h (18.6 mph) to 40 km/h (24.9 mph)Traktorenlexikon, “New Holland TL80”EvenEven on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap.
Which offers more PTO speeds?540/1000 rpmTraktorenlexikon, “Deutz-Fahr Agrotron 80”540/540E/1000 rpmTraktorenlexikon, “New Holland TL80”EvenEven on PTO speeds: the same speeds (540, 1000 rpm).
Which PTO runs independently of the ground drive?independentTraktorenlexikon, “Deutz-Fahr Agrotron 80”independentTraktorenlexikon, “New Holland TL80”EvenEven on PTO independence: every PTO is independent.
Which drives on both axles?4WDTraktorenlexikon, “Deutz-Fahr Agrotron 80”Two-wheel or four-wheel driveTraktorenlexikon, “New Holland TL80”EvenEven on drive: every machine is available with four-wheel drive.
Which is newer, and what about parts?1997–20011998–2004EvenSame era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts.

What does this mean in plain words?

  • The Deutz-Fahr Agrotron 80 has 86% more lift (2,870 kg / 6,327 lb) than the New Holland TL 80 (A) (both lift at the hitch ends, as stated by the source).
  • The Deutz-Fahr Agrotron 80 has 25% higher maximum permissible mass (1,300 kg / 2,866 lb) than the New Holland TL 80 (A) (both maximum permissible mass, as stated by the source).
  • Even on hydraulic flow (both pump flow, as stated by the source): the difference is under the 10% threshold, too small to call.
  • Even on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call.
  • Even on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap.
  • Even on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap.
  • Even on PTO speeds: the same speeds (540, 1000 rpm).
  • Even on PTO independence: every PTO is independent.
  • Even on drive: every machine is available with four-wheel drive.
  • Same era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts.
  • Not comparable on power at the PTO shaft: the Agrotron 80 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the TL 80 (A) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
  • No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power and a creeper range.

← Every figure for both machines, side by side, with sources