7 material differences · fewer than 12
Tractor oneDeutz-Fahr Agrotron 6190from 2013No measured PTO figureTractor twoNew Holland T 70402007–2011No measured PTO figure
Which should you choose?
We will not advise between these two machines, because they were not built in overlapping years (2013–2013; 2007–2011). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
7 material differences · 4 fields identical or within 5%, which is not counted as material
| Field | Agrotron 6190 | T 7040 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 181 hp | 179.6 hp | — |
| Engine declared | Deutz AG TCD 6.1 L06 4V | — | — |
| Displacement declared | 6.06 L | — | — |
| Maximum torque declared | 605 lb·ft · 820 N·m | 572 lb·ft · 776 N·m | +6% Agrotron 6190 |
| Transmission | |||
| Top speed declared | 24.9–31.1 mph · 40–50 km/h | 24.9–31.1 mph · 40–50 km/h | — |
| Clutch declared | Electro-hydraulically operated multi-plate clutch, running in an oil bath | Electrohydraulically operated wet Case-New Holland multi-plate clutch | differs |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Open centre | — | — |
| Pump flow declared | 21.9 gpm · 83 L/min | 32.0 gpm · 121.0 L/min | +46% T 7040 |
| Pressure declared | — | 3,336 psi · 230 bar | — |
| Rear PTO speeds declared | 540 rpm / 1000 rpm | 540/540E/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 14,683 lb · 6,660 kg | 17,758 lb · 8,055 kg | +21% T 7040 |
| Maximum permissible mass declared | — | 26,455 lb · 12,000 kg | — |
| Wheelbase declared | 108.9 in · 2,767 mm | 113.5 in · 2,884 mm | — |
| Length declared | 189.2 in · 4,806 mm | 189.6 in · 4,816 mm | — |
| Width declared | 98.4 in · 2,500 mm | 84.1–133.7 in · 2,135–3,395 mm | differs |
| Ground clearance declared | — | 16.5 in · 420 mm | — |
| Fuel tank declared | 264.2 qt · 250 L | 428.0 qt · 405.0 L | +62% T 7040 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Deutz-Fahr Agrotron 6190 sources
- Source: Traktorenlexikon, “Deutz-Fahr Agrotron 6190”
- Source: Traktorenlexikon, “Deutz-Fahr Agrotron 7250”
New Holland T 7040 sources
- Source: Traktorenlexikon, “New Holland T7040 Power Command”