4 material differences · fewer than 12
Tractor oneDeutz-Fahr Agrotron 6150from 2012No measured PTO figureTractor twoJohn Deere 68202002–2007No measured PTO figure
Which should you choose?
We will not advise between these two machines, because they were not built in overlapping years (2012–2012; 2002–2007). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
4 material differences · 5 fields identical or within 5%, which is not counted as material
| Field | Agrotron 6150 | 6820 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 135 hp | 133.3 hp | — |
| Engine declared | Deutz AG TCD 6.1 L06 4V | John Deere PowrTech 6.068 HLA-071/V2 or 6.068 HL-472/V4 | differs |
| Displacement declared | 6.06 L | 6.79 L | +12% 6820 |
| Maximum torque declared | 446 lb·ft · 605 N·m | — | — |
| Transmission | |||
| Top speed declared | — | 24.9–31.1 mph · 40–50 km/h | — |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Open centre | — | — |
| Hydraulic control declared | — | Load sensing | — |
| Pump flow declared | 21.9 gpm · 83.0 L/min | — | — |
| Rear PTO speeds declared | 540 rpm / 1000 rpm | 540 rpm / 1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 12,655 lb · 5,740 kg | 13,955–14,121 lb · 6,330–6,405 kg | differs |
| Maximum permissible mass declared | — | 23,149 lb · 10,500 kg | — |
| Wheelbase declared | 104.2 in · 2,647 mm | 104.3 in · 2,650 mm | — |
| Length declared | 184.5 in · 4,686 mm | 186.2 in · 4,730 mm | — |
| Width declared | 98.4 in · 2,500 mm | 96.5 in · 2,450 mm | — |
| Ground clearance declared | — | 21.6 in · 549 mm | — |
| Fuel tank declared | 295.9 qt · 280 L | 218.7 qt · 207.0 L | +35% Agrotron 6150 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Deutz-Fahr Agrotron 6150 sources
- Source: Traktorenlexikon, “Deutz-Fahr Agrotron 6150”
- Source: Traktorenlexikon, “Deutz-Fahr Agrotron 7250”
John Deere 6820 sources
- Source: Traktorenlexikon, “John Deere 6820”