Deutz-Fahr Agrotron 200 MK3 or Steyr 9200 a?
Which should you choose?
The data can’t decide this. Power at the PTO shaft cannot be compared: the Agrotron 200 MK3 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 9200 a has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.
What decides it, question by question?
| Question | Agrotron 200 MK3 | 9200 a | Call |
|---|---|---|---|
| Which puts more power through the PTO shaft? | 147.2 kW (197.4 hp)Traktorenlexikon, “Deutz-Fahr Agrotron 200 MK3” | 147.2 kW (197.4 hp)Traktorenlexikon, “Steyr 9200” | Not comparableNot comparable on power at the PTO shaft: the Agrotron 200 MK3 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 9200 a has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft. |
| Which turns a litre of fuel into more work at the shaft? | — | — | No figureNo call on fuel efficiency at the shaft: no figure on record for the Agrotron 200 MK3 and the 9200 a. |
| Which pulls harder at the drawbar? | — | — | No figureNo call on drawbar power: no figure on record for the Agrotron 200 MK3 and the 9200 a. |
| Which pumps more oil for implements? | 117.9 L/min (31.1 gpm)Traktorenlexikon, “Deutz-Fahr Agrotron 200 MK3” | 110.1 L/min (29.1 gpm)Traktorenlexikon, “Steyr 9200” | EvenEven on hydraulic flow (both pump flow, as stated by the source): the difference is under the 10% threshold, too small to call. |
| Which lifts more on the three-point hitch? | 10,000 kg (22,046 lb)Traktorenlexikon, “Deutz-Fahr Agrotron 200 MK3” | 8,580 kg (18,916 lb)Traktorenlexikon, “Steyr 9200” | Not comparableNot comparable on three-point lift: the Agrotron 200 MK3: lift at the hitch ends, as stated by the source (Traktorenlexikon, “Deutz-Fahr Agrotron 200 MK3”); the 9200 a: lift through the full range at an unstated point, as stated by the source (Traktorenlexikon, “Steyr 9200”) — not the same quantity, basis and condition. |
| Which is heavier, for traction? | 7,460 kg (16,446 lb)Traktorenlexikon, “Deutz-Fahr Agrotron 200 MK3” | 6,300 kg (13,889 lb)Traktorenlexikon, “Steyr 9200” | Ahead (a fact, not an advantage)The Deutz-Fahr Agrotron 200 MK3 is 18% heavier (1,160 kg / 2,557 lb) than the Steyr 9200 a (both unladen weight, as stated by the source). |
| Which may carry more ballast and load? | 12,000 kg (26,455 lb)Traktorenlexikon, “Deutz-Fahr Agrotron 200 MK3” | 11,000 kg (24,251 lb)Traktorenlexikon, “Steyr 9200” | EvenEven on maximum permissible mass (both maximum permissible mass, as stated by the source): the difference is under the 10% threshold, too small to call. |
| Which has the wider choice of gears? | 16 to 18Traktorenlexikon, “Deutz-Fahr Agrotron 200 MK3” | 32Traktorenlexikon, “Steyr 9200” | AheadThe Steyr 9200 a has 78% more forward gears (14 gears) than the Deutz-Fahr Agrotron 200 MK3 (both forward gears, as stated by the source). |
| Which offers a creeper range? | — | — | No figureNo call on a creeper range: not stated for the Agrotron 200 MK3 and the 9200 a. |
| Which is faster on the road? | 30 km/h (18.6 mph) to 40 km/h (24.9 mph)Traktorenlexikon, “Deutz-Fahr Agrotron 200 MK3” | 40 km/h (24.9 mph)Traktorenlexikon, “Steyr 9200” | EvenEven on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap. |
| Which offers more PTO speeds? | 540E/1000 rpmTraktorenlexikon, “Deutz-Fahr Agrotron 200 MK3” | 540/1000 rpmTraktorenlexikon, “Steyr 9200” | EvenEven on PTO speeds: the same speeds (540, 1000 rpm). |
| Which PTO runs independently of the ground drive? | independentTraktorenlexikon, “Deutz-Fahr Agrotron 200 MK3” | — | No figureNo call on PTO independence: not stated for the 9200 a. |
| Which drives on both axles? | 4WDTraktorenlexikon, “Deutz-Fahr Agrotron 200 MK3” | 4WDTraktorenlexikon, “Steyr 9200” | EvenEven on drive: every machine is available with four-wheel drive. |
| Which is newer, and what about parts? | 2001–2004 | 1995–1997 | Ahead (a fact, not an advantage)The Deutz-Fahr Agrotron 200 MK3 is newer: production began 6 years later. We hold no parts-availability data, so there is no call on parts. |
What does this mean in plain words?
- The Deutz-Fahr Agrotron 200 MK3 is 18% heavier (1,160 kg / 2,557 lb) than the Steyr 9200 a (both unladen weight, as stated by the source).
- The Steyr 9200 a has 78% more forward gears (14 gears) than the Deutz-Fahr Agrotron 200 MK3 (both forward gears, as stated by the source).
- The Deutz-Fahr Agrotron 200 MK3 is newer: production began 6 years later. We hold no parts-availability data, so there is no call on parts.
- Even on hydraulic flow (both pump flow, as stated by the source): the difference is under the 10% threshold, too small to call.
- Even on maximum permissible mass (both maximum permissible mass, as stated by the source): the difference is under the 10% threshold, too small to call.
- Even on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap.
- Even on PTO speeds: the same speeds (540, 1000 rpm).
- Even on drive: every machine is available with four-wheel drive.
- Not comparable on power at the PTO shaft: the Agrotron 200 MK3 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 9200 a has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
- Not comparable on three-point lift: the Agrotron 200 MK3: lift at the hitch ends, as stated by the source (Traktorenlexikon, “Deutz-Fahr Agrotron 200 MK3”); the 9200 a: lift through the full range at an unstated point, as stated by the source (Traktorenlexikon, “Steyr 9200”) — not the same quantity, basis and condition.
- No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, a creeper range and PTO independence.
← Every figure for both machines, side by side, with sources