11 material differences · fewer than 12

Tractor oneDeutz-Fahr AgroStar 6.711993–1997No measured PTO figureTractor twoFendt Favorit 716 Variofrom 1998No measured PTO figure

Which should you choose?

We will not advise between these two machines, because they were not built in overlapping years (1993–1997; 1998–1998). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.

Field by field

11 material differences · 3 fields identical or within 5%, which is not counted as material

Deutz-Fahr AgroStar 6.71 and Fendt Favorit 716 Vario, field by field
FieldAgroStar 6.71Favorit 716 VarioGap
Engine
Engine power, claimed claimed158 hp158 hp—
Engine declaredMWM TD 226 B-6Deutz AG BF6M 2013 Cdiffers
Displacement declared6.23 L5.70 L+9% AgroStar 6.71
Maximum torque declared471 lb·ft · 639 N·m558 lb·ft · 757.0 N·m+18% Favorit 716 Vario
Transmission
Top speed declared24.9 mph · 40 km/h31.1 mph · 50 km/h+25% Favorit 716 Vario
Clutch declared—Multi-plate clutch—
Hydraulics & hitch
Pump flow declared21.8 gpm · 82.7 L/min29.1 gpm · 110 L/min+33% Favorit 716 Vario
Pressure declared—2,901 psi · 200 bar—
Rear PTO speeds declared540/1000/750 rpm540/750/1000 rpmdiffers
Weight & dimensions
Unladen weight declared14,991 lb · 6,800 kg12,787–14,451 lb · 5,800–6,555 kgdiffers
Maximum permissible mass declared22,046 lb · 10,000 kg24,251 lb · 11,000 kg+10% Favorit 716 Vario
Wheelbase declared113.1 in · 2,872 mm106.3 in · 2,700 mm+6% AgroStar 6.71
Length declared199.2 in · 5,060 mm182.7–183.2 in · 4,640–4,653 mmdiffers
Width declared97.2 in · 2,470 mm101.2–102.0 in · 2,570–2,590 mm—
Ground clearance declared22.8 in · 580 mm22.7 in · 576 mm—
Turning radius, braked declared—16.1 ft · 4.90 m—
Fuel tank declared401.5 qt · 380 L322.3 qt · 305 L+25% AgroStar 6.71

Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.

Deutz-Fahr AgroStar 6.71 sources

Source
  • Source: Traktorenlexikon, “Deutz-Fahr AgroStar 6.71”
  • Source: Traktorenlexikon, “Fendt Favorit 615 LSA”

Fendt Favorit 716 Vario sources

Source
  • Source: Traktorenlexikon, “Fendt Favorit 716 Vario”
  • Source: OECD test report 1884, 2000