Deutz-Fahr AgroStar 6.28 or Fiat 115-90 (DT)?

Which should you choose?

The data can’t decide this. Power at the PTO shaft cannot be compared: the AgroStar 6.28 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 115-90 (DT) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.

  • The Deutz-Fahr AgroStar 6.28 suits road haulage better on this data: 13% (1,000 kg / 2,205 lb) more maximum permissible mass.

Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.

What decides it, question by question?

Buyer questions for Deutz-Fahr AgroStar 6.28 and Fiat 115-90 (DT), with the call on each
QuestionAgroStar 6.28115-90 (DT)Call
Which puts more power through the PTO shaft?84.6 kW (113.5 hp)Traktorenlexikon, “Deutz-Fahr AgroStar 6.28”84.6 kW (113.5 hp)Traktorenlexikon, “Fiatagri 115-90 DT”Not comparableNot comparable on power at the PTO shaft: the AgroStar 6.28 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 115-90 (DT) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
Which turns a litre of fuel into more work at the shaft?No figureNo call on fuel efficiency at the shaft: no figure on record for the AgroStar 6.28 and the 115-90 (DT).
Which pulls harder at the drawbar?No figureNo call on drawbar power: no figure on record for the AgroStar 6.28 and the 115-90 (DT).
Which pumps more oil for implements?55.0 L/min (14.5 gpm)Traktorenlexikon, “Deutz-Fahr AgroStar 6.28”55.6 L/min (14.7 gpm)Traktorenlexikon, “Fiatagri 115-90 DT”EvenEven on hydraulic flow (both pump flow, as stated by the source): the difference is under the 10% threshold, too small to call.
Which lifts more on the three-point hitch?6,500 kg (14,330 lb)Traktorenlexikon, “Deutz-Fahr AgroStar 6.28”No figureNo call on three-point lift: no figure on record for the 115-90 (DT).
Which is heavier, for traction?4,640 kg (10,229 lb)Traktorenlexikon, “Deutz-Fahr AgroStar 6.28”4,580 kg (10,097 lb)Traktorenlexikon, “Fiatagri 115-90 DT”EvenEven on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call.
Which may carry more ballast and load?8,500 kg (18,739 lb)Traktorenlexikon, “Deutz-Fahr AgroStar 6.28”7,500 kg (16,535 lb)Traktorenlexikon, “Fiatagri 115-90 DT”AheadThe Deutz-Fahr AgroStar 6.28 has 13% higher maximum permissible mass (1,000 kg / 2,205 lb) than the Fiat 115-90 (DT) (both maximum permissible mass, as stated by the source).
Which has the wider choice of gears?40 to 48Traktorenlexikon, “Deutz-Fahr AgroStar 6.28”12 to 24Traktorenlexikon, “Fiatagri 115-90 DT”AheadThe Deutz-Fahr AgroStar 6.28 has 67% more forward gears (16 gears) than the Fiat 115-90 (DT) (both forward gears, as stated by the source).
Which offers a creeper range?YesTraktorenlexikon, “Deutz-Fahr AgroStar 6.28”No figureNo call on a creeper range: not stated for the 115-90 (DT).
Which is faster on the road?30 km/h (18.6 mph) to 40 km/h (24.9 mph)Traktorenlexikon, “Deutz-Fahr AgroStar 6.28”30 km/h (18.6 mph) to 40 km/h (24.9 mph)Traktorenlexikon, “Fiatagri 115-90 DT”EvenEven on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap.
Which offers more PTO speeds?540/1000/750 rpmTraktorenlexikon, “Deutz-Fahr AgroStar 6.28”540/1000 rpmTraktorenlexikon, “Fiatagri 115-90 DT”AheadThe Deutz-Fahr AgroStar 6.28 offers 750 rpm at the PTO, which the Fiat 115-90 (DT) does not (as stated by the sources).
Which PTO runs independently of the ground drive?independentTraktorenlexikon, “Deutz-Fahr AgroStar 6.28”independentTraktorenlexikon, “Fiatagri 115-90 DT”EvenEven on PTO independence: every PTO is independent.
Which drives on both axles?4WDTraktorenlexikon, “Deutz-Fahr AgroStar 6.28”Two-wheel or four-wheel driveTraktorenlexikon, “Fiatagri 115-90 DT”EvenEven on drive: every machine is available with four-wheel drive.
Which is newer, and what about parts?1993–19951984–1990Ahead (a fact, not an advantage)The Deutz-Fahr AgroStar 6.28 is newer: production began 9 years later. We hold no parts-availability data, so there is no call on parts.

What does this mean in plain words?

  • The Deutz-Fahr AgroStar 6.28 has 13% higher maximum permissible mass (1,000 kg / 2,205 lb) than the Fiat 115-90 (DT) (both maximum permissible mass, as stated by the source).
  • The Deutz-Fahr AgroStar 6.28 has 67% more forward gears (16 gears) than the Fiat 115-90 (DT) (both forward gears, as stated by the source).
  • The Deutz-Fahr AgroStar 6.28 offers 750 rpm at the PTO, which the Fiat 115-90 (DT) does not (as stated by the sources).
  • The Deutz-Fahr AgroStar 6.28 is newer: production began 9 years later. We hold no parts-availability data, so there is no call on parts.
  • Even on hydraulic flow (both pump flow, as stated by the source): the difference is under the 10% threshold, too small to call.
  • Even on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call.
  • Even on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap.
  • Even on PTO independence: every PTO is independent.
  • Even on drive: every machine is available with four-wheel drive.
  • Not comparable on power at the PTO shaft: the AgroStar 6.28 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 115-90 (DT) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
  • No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, three-point lift and a creeper range.

← Every figure for both machines, side by side, with sources