5 material differences · fewer than 12

Tractor oneDeutz-Fahr AgroStar 4.711990–1993No measured PTO figureTractor twoMassey Ferguson MF 6150 (A)1995–1999No measured PTO figure

Which should you choose?

We will not advise between these two machines, because the drive differs (4WD; Two-wheel or four-wheel drive); they were not built in overlapping years (1990–1993; 1995–1999). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.

Field by field

5 material differences · 8 fields identical or within 5%, which is not counted as material

Deutz-Fahr AgroStar 4.71 and Massey Ferguson MF 6150 (A), field by field
FieldAgroStar 4.71MF 6150 (A)Gap
Engine
Engine power, claimed claimed93.7 hp93.7 hp—
Engine declaredKHD BF4L 913Perkins 1004-4 THR2differs
Displacement declared4.09 L3.99 L—
Maximum torque declared270 lb·ft · 366 N·m261 lb·ft · 354 N·m—
Transmission
Top speed declared18.6–24.9 mph · 30–40 km/h18.6–24.9 mph · 30–40 km/h—
Clutch declared—Mechanically operated dry VALEO single-plate clutch—
Hydraulics & hitch
Pump flow declared13.0 gpm · 49.2 L/min15.4 gpm · 58.2 L/min+18% MF 6150 (A)
Pressure declared—2,901 psi · 200 bar—
Rear PTO speeds declared540/1000/750 rpm540/1000/540E/1000E rpmdiffers
Weight & dimensions
Unladen weight declared9,259 lb · 4,200 kg8,785 lb · 3,985 kg+5% AgroStar 4.71
Maximum permissible mass declared16,535 lb · 7,500 kg16,535 lb · 7,500 kg—
Wheelbase declared96.5 in · 2,450 mm100.4 in · 2,549 mm—
Length declared168.2 in · 4,272 mm171.3 in · 4,350 mm—
Width declared90.2 in · 2,290 mm91.7 in · 2,330 mm—
Ground clearance declared18.3 in · 465 mm16.9 in · 430 mm+8% AgroStar 4.71
Fuel tank declared—169.1 qt · 160.0 L—

Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.

Deutz-Fahr AgroStar 4.71 sources

Source
  • Source: Traktorenlexikon, “Deutz-Fahr AgroStar 4.71”
  • Source: Traktorenlexikon, “Deutz-Fahr AgroStar 4.78”

Massey Ferguson MF 6150 (A) sources

Source
  • Source: Traktorenlexikon, “Massey Ferguson MF 6150”
  • Source: Traktorenlexikon, “Massey Ferguson MF 3075”