Deutz-Fahr AgroStar 4.71 or Fiat TL 100 (DT)?
Which should you choose?
The data can’t decide this. Power at the PTO shaft cannot be compared: the AgroStar 4.71 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the TL 100 (DT) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
- The Deutz-Fahr AgroStar 4.71 suits road haulage better on this data: 25% (1,500 kg / 3,307 lb) more maximum permissible mass.
Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.
What decides it, question by question?
| Question | AgroStar 4.71 | TL 100 (DT) | Call |
|---|---|---|---|
| Which puts more power through the PTO shaft? | 69.9 kW (93.7 hp)Traktorenlexikon, “Deutz-Fahr AgroStar 4.71” | 69.9 kW (93.7 hp)Traktorenlexikon, “Fiatagri TL100” | Not comparableNot comparable on power at the PTO shaft: the AgroStar 4.71 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the TL 100 (DT) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft. |
| Which turns a litre of fuel into more work at the shaft? | — | — | No figureNo call on fuel efficiency at the shaft: no figure on record for the AgroStar 4.71 and the TL 100 (DT). |
| Which pulls harder at the drawbar? | — | — | No figureNo call on drawbar power: no figure on record for the AgroStar 4.71 and the TL 100 (DT). |
| Which pumps more oil for implements? | 49.2 L/min (13.0 gpm)Traktorenlexikon, “Deutz-Fahr AgroStar 4.71” | 60.0 L/min (15.9 gpm)Traktorenlexikon, “Fiatagri TL100” | AheadThe Fiat TL 100 (DT) has 22% more hydraulic flow (10.8 L/min / 2.9 gpm) than the Deutz-Fahr AgroStar 4.71 (both pump flow, as stated by the source). |
| Which lifts more on the three-point hitch? | 5,200 kg (11,464 lb)Traktorenlexikon, “Deutz-Fahr AgroStar 4.71” | 3,880 kg (8,554 lb)Traktorenlexikon, “Fiatagri TL100” | AheadThe Deutz-Fahr AgroStar 4.71 has 34% more lift (1,320 kg / 2,910 lb) than the Fiat TL 100 (DT) (both lift at the hitch ends, as stated by the source). |
| Which is heavier, for traction? | 4,200 kg (9,259 lb)Traktorenlexikon, “Deutz-Fahr AgroStar 4.71” | 4,365 kg (9,623 lb)Traktorenlexikon, “Fiatagri TL100” | EvenEven on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call. |
| Which may carry more ballast and load? | 7,500 kg (16,535 lb)Traktorenlexikon, “Deutz-Fahr AgroStar 4.71” | 6,000 kg (13,228 lb)Traktorenlexikon, “Fiatagri TL100” | AheadThe Deutz-Fahr AgroStar 4.71 has 25% higher maximum permissible mass (1,500 kg / 3,307 lb) than the Fiat TL 100 (DT) (both maximum permissible mass, as stated by the source). |
| Which has the wider choice of gears? | 18Traktorenlexikon, “Deutz-Fahr AgroStar 4.71” | 20 to 24Traktorenlexikon, “Fiatagri TL100” | EvenEven on forward gears (both forward gears, as stated by the source): the difference is under the 25% threshold, too small to call. |
| Which offers a creeper range? | — | YesTraktorenlexikon, “Fiatagri TL100” | No figureNo call on a creeper range: not stated for the AgroStar 4.71. |
| Which is faster on the road? | 30 km/h (18.6 mph) to 40 km/h (24.9 mph)Traktorenlexikon, “Deutz-Fahr AgroStar 4.71” | 30 km/h (18.6 mph) to 40 km/h (24.9 mph)Traktorenlexikon, “Fiatagri TL100” | EvenEven on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap. |
| Which offers more PTO speeds? | 540/1000/750 rpmTraktorenlexikon, “Deutz-Fahr AgroStar 4.71” | 540/540E/1000 rpmTraktorenlexikon, “Fiatagri TL100” | AheadThe Deutz-Fahr AgroStar 4.71 offers 750 rpm at the PTO, which the Fiat TL 100 (DT) does not (as stated by the sources). |
| Which PTO runs independently of the ground drive? | independentTraktorenlexikon, “Deutz-Fahr AgroStar 4.71” | — | No figureNo call on PTO independence: not stated for the TL 100 (DT). |
| Which drives on both axles? | 4WDTraktorenlexikon, “Deutz-Fahr AgroStar 4.71” | Two-wheel or four-wheel driveTraktorenlexikon, “Fiatagri TL100” | EvenEven on drive: every machine is available with four-wheel drive. |
| Which is newer, and what about parts? | 1990–1993 | 1998–2004 | Ahead (a fact, not an advantage)The Fiat TL 100 (DT) is newer: production began 8 years later. We hold no parts-availability data, so there is no call on parts. |
What does this mean in plain words?
- The Fiat TL 100 (DT) has 22% more hydraulic flow (10.8 L/min / 2.9 gpm) than the Deutz-Fahr AgroStar 4.71 (both pump flow, as stated by the source).
- The Deutz-Fahr AgroStar 4.71 has 34% more lift (1,320 kg / 2,910 lb) than the Fiat TL 100 (DT) (both lift at the hitch ends, as stated by the source).
- The Deutz-Fahr AgroStar 4.71 has 25% higher maximum permissible mass (1,500 kg / 3,307 lb) than the Fiat TL 100 (DT) (both maximum permissible mass, as stated by the source).
- The Deutz-Fahr AgroStar 4.71 offers 750 rpm at the PTO, which the Fiat TL 100 (DT) does not (as stated by the sources).
- The Fiat TL 100 (DT) is newer: production began 8 years later. We hold no parts-availability data, so there is no call on parts.
- Even on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call.
- Even on forward gears (both forward gears, as stated by the source): the difference is under the 25% threshold, too small to call.
- Even on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap.
- Even on drive: every machine is available with four-wheel drive.
- Not comparable on power at the PTO shaft: the AgroStar 4.71 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the TL 100 (DT) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
- No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, a creeper range and PTO independence.
← Every figure for both machines, side by side, with sources