4 material differences · fewer than 12
Tractor oneDeutz-Fahr Agroplus S 410from 2009No measured PTO figureTractor twoSAME Golden 85 Compatto (SAME)1998–2003No measured PTO figure
Which should you choose?
We will not advise between these two machines, because they were not built in overlapping years (2009–2009; 1998–2003). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
4 material differences · 7 fields identical or within 5%, which is not counted as material
| Field | Agroplus S 410 | Golden 85 Compatto | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 83.8 hp | 83.8 hp | — |
| Engine declared | Same 1000.4 WT | SAME-DEUTZ-FAHR 1000.4 AT 1 | differs |
| Displacement declared | 4.00 L | 4.00 L | — |
| Maximum torque declared | — | 206 lb·ft · 279 N·m | — |
| Transmission | |||
| Top speed declared | 24.9 mph · 40 km/h | 24.9 mph · 40 km/h | — |
| Clutch declared | — | Pedal-operated dry single-plate clutch | — |
| Hydraulics & hitch | |||
| Pump flow declared | 14.3 gpm · 54.0 L/min | 8.9 gpm · 33.8 L/min | +60% Agroplus S 410 |
| Pressure declared | — | 3,118 psi · 215 bar | — |
| Rear PTO speeds declared | 540 rpm / 1000 rpm | 540/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 5,798 lb · 2,630 kg | 5,534 lb · 2,510 kg | — |
| Wheelbase declared | 80.9 in · 2,056 mm | 80.9 in · 2,056 mm | — |
| Length declared | 145.9 in · 3,706 mm | 140.2 in · 3,561 mm | — |
| Width declared | — | 50.8–64.6 in · 1,290–1,640 mm | — |
| Ground clearance declared | 9.8 in · 250 mm | 9.1 in · 230 mm | +9% Agroplus S 410 |
| Turning radius, braked declared | — | 13.3 ft · 4.05 m | — |
| Fuel tank declared | 58.1 qt · 55 L | 58.1 qt · 55.0 L | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Deutz-Fahr Agroplus S 410 sources
- Source: Traktorenlexikon, “Deutz-Fahr Agroplus S 410”
SAME Golden 85 Compatto (SAME) sources
- Source: Traktorenlexikon, “SAME Golden 85 Compatto”
- Source: OECD test report 1839, 1999