8 material differences · fewer than 12
Tractor oneDeutz-Fahr Agroplus S 1002005–2007No measured PTO figureTractor twoNew Holland TN 95 DA2006–2007No measured PTO figure
Which should you choose?
Read our verdict on the Agroplus S 100 and the TN 95 DA → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
8 material differences · 4 fields identical or within 5%, which is not counted as material
| Field | Agroplus S 100 | TN 95 DA | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 89 hp | 89 hp | — |
| Engine declared | Lamborghini 1000.4 WT | — | — |
| Displacement declared | 4.00 L | — | — |
| Maximum torque declared | 278 lb·ft · 377 N·m | 268 lb·ft · 364 N·m | — |
| Transmission | |||
| Top speed declared | 24.9 mph · 40 km/h | 24.9 mph · 40 km/h | — |
| Clutch declared | Single-plate dry clutch | Oil-immersed multi-plate clutch with six plates of 113 mm diameter | differs |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Open centre | — | — |
| Hydraulic control declared | — | Constant flow | — |
| Pump flow declared | 14.3 gpm · 54.0 L/min | 12.5 gpm · 47.4 L/min | +14% Agroplus S 100 |
| Rear PTO speeds declared | 540/540E/1000 rpm | 540/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 5,952 lb · 2,700 kg | 6,724 lb · 3,050 kg | +13% TN 95 DA |
| Wheelbase declared | 80.9 in · 2,056 mm | 86.0 in · 2,185 mm | +6% TN 95 DA |
| Length declared | 145.9 in · 3,706 mm | 140.5 in · 3,568 mm | — |
| Width declared | 59.1–76.0 in · 1,500–1,930 mm | 79.1 in · 2,010 mm | differs |
| Ground clearance declared | 11.0 in · 280 mm | 14.2 in · 360 mm | +29% TN 95 DA |
| Fuel tank declared | 58.1 qt · 55 L | 93.0 qt · 88 L | +60% TN 95 DA |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Deutz-Fahr Agroplus S 100 sources
- Source: Traktorenlexikon, “Deutz-Fahr Agroplus S 100”
- Source: Traktorenlexikon, “Deutz-Fahr Agroplus S 90”
New Holland TN 95 DA sources
- Source: Traktorenlexikon, “New Holland TN95 DA”
- Source: OECD test report 2346, 2006