6 material differences · fewer than 12
Tractor oneDeutz-Fahr Agroplus 951997–2005No measured PTO figureTractor twoFendt Favorit 509 C1994–2000No measured PTO figure
Which should you choose?
We will not advise between these two machines, because their unladen weight differs by more than 25% (31%); the drive differs (Two-wheel or four-wheel drive; 4WD). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
6 material differences · 4 fields identical or within 5%, which is not counted as material
| Field | Agroplus 95 | Favorit 509 C | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 92.8 hp | 93.2 hp | — |
| Engine declared | — | MWM TD 226. B-4 | — |
| Displacement declared | — | 4.16 L | — |
| Maximum torque declared | 263 lb·ft · 357 N·m | 281 lb·ft · 381 N·m | +7% Favorit 509 C |
| Transmission | |||
| Top speed declared | 24.9 mph · 40 km/h | 24.9–31.1 mph · 40–50 km/h | differs |
| Clutch declared | — | Wet multi-plate drive clutch | — |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Open centre | — | — |
| Pump flow declared | — | 26.5 gpm · 100.2 L/min | — |
| Pressure declared | — | 2,538 psi · 175 bar | — |
| Rear PTO speeds declared | 540 rpm / 1000 rpm | 540 rpm / 750 rpm / 1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 8,378 lb · 3,800 kg | 10,957 lb · 4,970 kg | +31% Favorit 509 C |
| Maximum permissible mass declared | 13,669 lb · 6,200 kg | — | — |
| Wheelbase declared | 92.1 in · 2,340 mm | 91.9 in · 2,333 mm | — |
| Length declared | 146.2 in · 3,714 mm | 164.6 in · 4,180 mm | +13% Favorit 509 C |
| Width declared | 81.1 in · 2,060 mm | 84.3 in · 2,140 mm | — |
| Ground clearance declared | 18.6 in · 472 mm | 21.1 in · 536 mm | +14% Favorit 509 C |
| Turning radius, braked declared | — | 13.1 ft · 4.00 m | — |
| Fuel tank declared | 147.9 qt · 140 L | 142.7 qt · 135 L | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Deutz-Fahr Agroplus 95 sources
- Source: Traktorenlexikon, “Deutz-Fahr Agroplus 95”
Fendt Favorit 509 C sources
- Source: Traktorenlexikon, “Fendt Favorit 509 C”
- Source: Traktorenlexikon, “Fendt Farmer 308”