6 material differences · fewer than 12
Tractor oneDeutz-Fahr Agroplus 772006–2009No measured PTO figureTractor twoDeutz-Fahr Agroplus-S 752005–2007No measured PTO figure
Which should you choose?
We will not advise between these two machines, because the drive differs (Two-wheel or four-wheel drive; 4WD). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
6 material differences · 7 fields identical or within 5%, which is not counted as material
| Field | Agroplus 77 | Agroplus-S 75 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 69.1 hp | 69.1 hp | — |
| Engine declared | SLH 1.000.4 W | Lamborghini 1000.4 W | differs |
| Displacement declared | 4.00 L | 4.00 L | — |
| Maximum torque declared | 190 lb·ft · 257 N·m | 190 lb·ft · 257 N·m | — |
| Transmission | |||
| Top speed declared | 24.9 mph · 40 km/h | 24.9 mph · 40 km/h | — |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Open centre | — | — |
| Pump flow declared | 14.3 gpm · 54.0 L/min | 14.3 gpm · 54.0 L/min | — |
| Rear PTO speeds declared | 540 rpm / 1000 rpm | 540/540E/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 5,952 lb · 2,700 kg | 5,952 lb · 2,700 kg | — |
| Maximum permissible mass declared | 9,921 lb · 4,500 kg | — | — |
| Wheelbase declared | 88.0 in · 2,235 mm | 80.9 in · 2,056 mm | +9% Agroplus 77 |
| Length declared | 140.2 in · 3,560 mm | 145.9 in · 3,706 mm | — |
| Width declared | 82.7 in · 2,100 mm | 59.1–76.0 in · 1,500–1,930 mm | differs |
| Ground clearance declared | 17.5 in · 445 mm | 9.8 in · 250 mm | +78% Agroplus 77 |
| Fuel tank declared | 95.1 qt · 90 L | 58.1 qt · 55 L | +64% Agroplus 77 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Deutz-Fahr Agroplus 77 sources
- Source: Traktorenlexikon, “Deutz-Fahr Agroplus 77”
Deutz-Fahr Agroplus-S 75 sources
- Source: Traktorenlexikon, “Deutz-Fahr Agroplus S 75”