Deutz-Fahr Agroplus 70 or Fiat 72-86 (DT)?

Which should you choose?

The data can’t decide this. Power at the PTO shaft cannot be compared: the Agroplus 70 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 72-86 (DT) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.

Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.

What decides it, question by question?

Buyer questions for Deutz-Fahr Agroplus 70 and Fiat 72-86 (DT), with the call on each
QuestionAgroplus 7072-86 (DT)Call
Which puts more power through the PTO shaft?51.5 kW (69.1 hp)Traktorenlexikon, “Deutz-Fahr Agroplus 70”51.5 kW (69.1 hp)Traktorenlexikon, “Fiatagri 72-86 F/72-86 F/DT”Not comparableNot comparable on power at the PTO shaft: the Agroplus 70 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 72-86 (DT) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
Which turns a litre of fuel into more work at the shaft?No figureNo call on fuel efficiency at the shaft: no figure on record for the Agroplus 70 and the 72-86 (DT).
Which pulls harder at the drawbar?No figureNo call on drawbar power: no figure on record for the Agroplus 70 and the 72-86 (DT).
Which pumps more oil for implements?44.7 L/min (11.8 gpm)Traktorenlexikon, “Deutz-Fahr Agroplus 70”No figureNo call on hydraulic flow: no figure on record for the 72-86 (DT).
Which lifts more on the three-point hitch?2,900 kg (6,393 lb)Traktorenlexikon, “Deutz-Fahr Agroplus 70”3,045 kg (6,713 lb)Traktorenlexikon, “Fiatagri 72-86 F/72-86 F/DT”EvenEven on three-point lift (both lift at the hitch ends, as stated by the source): the difference is under the 10% threshold, too small to call.
Which is heavier, for traction?2,750 kg (6,063 lb)Traktorenlexikon, “Deutz-Fahr Agroplus 70”1,947 kg (4,292 lb)Traktorenlexikon, “Fiatagri 72-86 F/72-86 F/DT”Ahead (a fact, not an advantage)The Deutz-Fahr Agroplus 70 is 41% heavier (803 kg / 1,770 lb) than the Fiat 72-86 (DT) (both unladen weight, as stated by the source).
Which may carry more ballast and load?4,500 kg (9,921 lb)Traktorenlexikon, “Deutz-Fahr Agroplus 70”No figureNo call on maximum permissible mass: no figure on record for the 72-86 (DT).
Which has the wider choice of gears?20Traktorenlexikon, “Deutz-Fahr Agroplus 70”12 to 20Traktorenlexikon, “Fiatagri 72-86 F/72-86 F/DT”Sources disagreeNo call on forward gears: sources disagree on the figure for the Agroplus 70.
Which offers a creeper range?No figureNo call on a creeper range: not stated for the Agroplus 70 and the 72-86 (DT).
Which is faster on the road?40 km/h (24.9 mph)Traktorenlexikon, “Deutz-Fahr Agroplus 70”30 km/h (18.6 mph) to 40 km/h (24.9 mph)Traktorenlexikon, “Fiatagri 72-86 F/72-86 F/DT”EvenEven on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap.
Which offers more PTO speeds?540/1000 rpmTraktorenlexikon, “Deutz-Fahr Agroplus 70”540 rpmTraktorenlexikon, “Fiatagri 72-86 F/72-86 F/DT”AheadThe Deutz-Fahr Agroplus 70 offers 1000 rpm at the PTO, which the Fiat 72-86 (DT) does not (as stated by the sources).
Which PTO runs independently of the ground drive?independentTraktorenlexikon, “Deutz-Fahr Agroplus 70”No figureNo call on PTO independence: not stated for the 72-86 (DT).
Which drives on both axles?2WD / 4WDTraktorenlexikon, “Deutz-Fahr Agroplus 70”; OECD test report 1686, 1997Two-wheel or four-wheel driveTraktorenlexikon, “Fiatagri 72-86 F/72-86 F/DT”EvenEven on drive: every machine is available with four-wheel drive.
Which is newer, and what about parts?1997–20051992–2000Ahead (a fact, not an advantage)The Deutz-Fahr Agroplus 70 is newer: production began 5 years later. We hold no parts-availability data, so there is no call on parts.

What does this mean in plain words?

  • The Deutz-Fahr Agroplus 70 is 41% heavier (803 kg / 1,770 lb) than the Fiat 72-86 (DT) (both unladen weight, as stated by the source).
  • The Deutz-Fahr Agroplus 70 offers 1000 rpm at the PTO, which the Fiat 72-86 (DT) does not (as stated by the sources).
  • The Deutz-Fahr Agroplus 70 is newer: production began 5 years later. We hold no parts-availability data, so there is no call on parts.
  • Even on three-point lift (both lift at the hitch ends, as stated by the source): the difference is under the 10% threshold, too small to call.
  • Even on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap.
  • Even on drive: every machine is available with four-wheel drive.
  • Not comparable on power at the PTO shaft: the Agroplus 70 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 72-86 (DT) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
  • No call on forward gears: sources disagree on the figure for the Agroplus 70.
  • No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, hydraulic flow, maximum permissible mass, a creeper range and PTO independence.

← Every figure for both machines, side by side, with sources