13 material differences

Tractor oneDeutz-Fahr Agroplus 60 (Traktorenlexikon)1997–2005No measured PTO figureTractor twoFord 4130 (A)1990–1996No measured PTO figure

Which should you choose?

We will not advise between these two machines, because they were not built in overlapping years (1997–2005; 1990–1996). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.

Field by field

13 material differences · 3 fields identical or within 5%, which is not counted as material

Deutz-Fahr Agroplus 60 (Traktorenlexikon) and Ford 4130 (A), field by field
FieldAgroplus 604130 (A)Gap
Engine
Engine power, claimed claimed55.3 hp55.3 hp—
Engine declaredKHD F3L 913 or F3L 914Ford K 201 CID-NAdiffers
Displacement declared—3.29 L—
Maximum torque declared131 lb·ft · 177 N·m143 lb·ft · 194 N·m+10% 4130 (A)
Transmission
Top speed declared24.9 mph · 40 km/h18.6–24.9 mph · 30–40 km/hdiffers
Clutch declaredMechanically operated, dry Borg & Beck single clutch, type: 305Pedal operated dry AP single-disc clutchdiffers
Hydraulics & hitch
Hydraulic centre declaredOpen centreOpen centre—
Pump flow declared12.5 gpm · 47.5 L/min9.3 gpm · 35.3 L/min+35% Agroplus 60
Pressure declared2,031 psi · 140 bar1,378–1,450 psi · 95–100 bardiffers
Three-point lift, at the coupling points declared6,393 lb · 2,900 kg4,381 lb · 1,987 kg+46% Agroplus 60
Rear PTO speeds declared540/1000 rpm540 rpmdiffers
Weight & dimensions
Unladen weight declared5,192 lb · 2,355 kg6,155 lb · 2,792 kg+19% 4130 (A)
Maximum permissible mass declared9,921 lb · 4,500 kg——
Wheelbase declared82.9 in · 2,105 mm84.5 in · 2,146 mm—
Length declared154.7 in · 3,930 mm138.6 in · 3,521 mm+12% Agroplus 60
Width declared79.1 in · 2,008 mm69.7–96.7 in · 1,771–2,457 mmdiffers
Ground clearance declared16.7 in · 425 mm13.9 in · 353 mm+20% Agroplus 60
Fuel tank declared95.1 qt · 90 L69.4 qt · 65.7 L+37% Agroplus 60

Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.

Deutz-Fahr Agroplus 60 (Traktorenlexikon) sources

Source
  • Source: Traktorenlexikon, “Deutz-Fahr Agroplus 60”

Ford 4130 (A) sources

Source
  • Source: Traktorenlexikon, “Ford 4130”