11 material differences · fewer than 12

Tractor oneDeutz-Fahr Agroplus 420 ( Profiline )from 2009No measured PTO figureTractor twoMassey Ferguson MF 6255 (A)1999–2003No measured PTO figure

Which should you choose?

We will not advise between these two machines, because the drive differs (4WD; Two-wheel or four-wheel drive); they were not built in overlapping years (2009–2009; 1999–2003). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.

Field by field

11 material differences · 3 fields identical or within 5%, which is not counted as material

Deutz-Fahr Agroplus 420 ( Profiline ) and Massey Ferguson MF 6255 (A), field by field
FieldAgroplus 420 ( Profiline )MF 6255 (A)Gap
Engine
Engine power, claimed claimed94 hp93.7 hp—
Engine declaredSame 1000.4 WTI 2 E3Perkins 1004.40 TWGdiffers
Displacement declared4.00 L3.99 L—
Maximum torque declared275 lb·ft · 373 N·m253 lb·ft · 343 N·m+9% Agroplus 420 ( Profiline )
Transmission
Top speed declared24.9 mph · 40 km/h24.9 mph · 40 km/h—
Clutch declaredHydraulically operated single dry clutchPedal operated hydraulic VALEO multi-plate clutchdiffers
Hydraulics & hitch
Pump flow declared10.8 gpm · 41.0 L/min25.3 gpm · 95.7 L/min+133% MF 6255 (A)
Pressure declared—3,336 psi · 230 bar—
Rear PTO speeds declared540/540E/1000 rpm540/1000/540E/1000E rpmdiffers
Weight & dimensions
Unladen weight declared7,518 lb · 3,410 kg9,248 lb · 4,195 kg+23% MF 6255 (A)
Maximum permissible mass declared—19,401 lb · 8,800 kg—
Wheelbase declared87.8 in · 2,230 mm97.8 in · 2,485 mm+11% MF 6255 (A)
Length declared140.2 in · 3,560 mm171.3 in · 4,350 mm+22% MF 6255 (A)
Width declared81.5–91.7 in · 2,070–2,330 mm81.5–98.4 in · 2,071–2,500 mmdiffers
Ground clearance declared15.4 in · 390 mm16.9 in · 430 mm+10% MF 6255 (A)
Turning radius, braked declared12.8 ft · 3.90 m——
Fuel tank declared95.1 qt · 90 L137.4 qt · 130.0 L+44% MF 6255 (A)

Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.

Deutz-Fahr Agroplus 420 ( Profiline ) sources

Source
  • Source: Traktorenlexikon, “Deutz-Fahr Agroplus 420”
  • Source: Traktorenlexikon, “Deutz-Fahr Agroplus 410”

Massey Ferguson MF 6255 (A) sources

Source
  • Source: Traktorenlexikon, “Massey Ferguson MF 6255”
  • Source: Traktorenlexikon, “Massey Ferguson MF 4355”