10 material differences · fewer than 12

Tractor oneDeutz-Fahr Agroplus 420 ( Profiline )from 2009No measured PTO figureTractor twoFiat TL 100 (DT)1998–2004No measured PTO figure

Which should you choose?

We will not advise between these two machines, because their unladen weight differs by more than 25% (28%); the drive differs (4WD; Two-wheel or four-wheel drive); they were not built in overlapping years (2009–2009; 1998–2004). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.

Field by field

10 material differences · 4 fields identical or within 5%, which is not counted as material

Deutz-Fahr Agroplus 420 ( Profiline ) and Fiat TL 100 (DT), field by field
FieldAgroplus 420 ( Profiline )TL 100 (DT)Gap
Engine
Engine power, claimed claimed94 hp93.7 hp—
Engine declaredSame 1000.4 WTI 2 E3New Holland-Iveco 8045.25 Kdiffers
Displacement declared4.00 L3.91 L—
Maximum torque declared275 lb·ft · 373 N·m245 lb·ft · 332 N·m+12% Agroplus 420 ( Profiline )
Transmission
Top speed declared24.9 mph · 40 km/h18.6–24.9 mph · 30–40 km/hdiffers
Clutch declaredHydraulically operated single dry clutch——
Hydraulics & hitch
Pump flow declared10.8 gpm · 41.0 L/min15.9 gpm · 60.0 L/min+46% TL 100 (DT)
Pressure declared—2,103 psi · 145 bar—
Rear PTO speeds declared540/540E/1000 rpm540/540E/1000 rpm—
Weight & dimensions
Unladen weight declared7,518 lb · 3,410 kg9,623 lb · 4,365 kg+28% TL 100 (DT)
Maximum permissible mass declared—13,228 lb · 6,000 kg—
Wheelbase declared87.8 in · 2,230 mm92.2 in · 2,342 mm—
Length declared140.2 in · 3,560 mm174.4 in · 4,430 mm+24% TL 100 (DT)
Width declared81.5–91.7 in · 2,070–2,330 mm79.1–105.7 in · 2,009–2,684 mmdiffers
Ground clearance declared15.4 in · 390 mm17.3 in · 440 mm+13% TL 100 (DT)
Turning radius, braked declared12.8 ft · 3.90 m12.0 ft · 3.65 m+7% Agroplus 420 ( Profiline )
Fuel tank declared95.1 qt · 90 L121.5 qt · 115.0 L+28% TL 100 (DT)

Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.

Deutz-Fahr Agroplus 420 ( Profiline ) sources

Source
  • Source: Traktorenlexikon, “Deutz-Fahr Agroplus 420”
  • Source: Traktorenlexikon, “Deutz-Fahr Agroplus 410”

Fiat TL 100 (DT) sources

Source
  • Source: Traktorenlexikon, “Fiatagri TL100”