12 material differences

Tractor oneDeutz-Fahr Agroplus 420 ( Profiline )from 2009No measured PTO figureTractor twoDeutz-Fahr Agrotron 100 MK32001–2003No measured PTO figure

Which should you choose?

We will not advise between these two machines, because they were not built in overlapping years (2009–2009; 2001–2003). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.

Field by field

12 material differences · 2 fields identical or within 5%, which is not counted as material

Deutz-Fahr Agroplus 420 ( Profiline ) and Deutz-Fahr Agrotron 100 MK3, field by field
FieldAgroplus 420 ( Profiline )Agrotron 100 MK3Gap
Engine
Engine power, claimed claimed94 hp93.7 hp—
Engine declaredSame 1000.4 WTI 2 E3Deutz BF4M 1012 ECdiffers
Displacement declared4.00 L3.19 L+25% Agroplus 420 ( Profiline )
Maximum torque declared275 lb·ft · 373 N·m271 lb·ft · 368 N·m—
Transmission
Top speed declared24.9 mph · 40 km/h18.6–24.9 mph · 30–40 km/hdiffers
Clutch declaredHydraulically operated single dry clutchHydraulically operated multi-disc clutch running in an oil bathdiffers
Hydraulics & hitch
Hydraulic centre declared—Open centre—
Pump flow declared10.8 gpm · 41.0 L/min18.9 gpm · 71.7 L/min+75% Agrotron 100 MK3
Rear PTO speeds declared540/540E/1000 rpm540 rpm / 1000 rpmdiffers
Weight & dimensions
Unladen weight declared7,518 lb · 3,410 kg9,304 lb · 4,220 kg+24% Agrotron 100 MK3
Maximum permissible mass declared—16,535 lb · 7,500 kg—
Wheelbase declared87.8 in · 2,230 mm95.2 in · 2,419 mm+8% Agrotron 100 MK3
Length declared140.2 in · 3,560 mm163.0 in · 4,139 mm+16% Agrotron 100 MK3
Width declared81.5–91.7 in · 2,070–2,330 mm81.1 in · 2,060 mmdiffers
Ground clearance declared15.4 in · 390 mm19.1 in · 485 mm+24% Agrotron 100 MK3
Turning radius, braked declared12.8 ft · 3.90 m——
Fuel tank declared95.1 qt · 90 L200.8 qt · 190 L+111% Agrotron 100 MK3

Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.

Deutz-Fahr Agroplus 420 ( Profiline ) sources

Source
  • Source: Traktorenlexikon, “Deutz-Fahr Agroplus 420”
  • Source: Traktorenlexikon, “Deutz-Fahr Agroplus 410”

Deutz-Fahr Agrotron 100 MK3 sources

Source
  • Source: Traktorenlexikon, “Deutz-Fahr Agrotron 100 MK3”
  • Source: Traktorenlexikon, “Deutz-Fahr Agrotron 100”