7 material differences · fewer than 12
Tractor oneDeutz-Fahr Agroplus 310from 2009No measured PTO figureTractor twoSteyr M 963 (a)2001–2004No measured PTO figure
Which should you choose?
We will not advise between these two machines, because their unladen weight differs by more than 25% (30%); the drive differs (4WD; Two-wheel or four-wheel drive); they were not built in overlapping years (2009–2009; 2001–2004). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
7 material differences · 4 fields identical or within 5%, which is not counted as material
| Field | Agroplus 310 | M 963 (a) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 62.4 hp | 62.2 hp | — |
| Engine declared | Same 1000.3 WTE3 | PERKINS 903-27 T | differs |
| Displacement declared | 3.00 L | 2.70 L | +11% Agroplus 310 |
| Maximum torque declared | 180 lb·ft · 244 N·m | 176 lb·ft · 239 N·m | — |
| Transmission | |||
| Top speed declared | 24.9 mph · 40 km/h | 18.6–24.9 mph · 30–40 km/h | differs |
| Hydraulics & hitch | |||
| Pump flow declared | — | 8.1 gpm · 30.8 L/min | — |
| Pressure declared | — | 3,481 psi · 240 bar | — |
| Rear PTO speeds declared | 540 rpm / 1000 rpm | 540/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 7,121 lb · 3,230 kg | 5,490 lb · 2,490 kg | +30% Agroplus 310 |
| Wheelbase declared | 82.7 in · 2,100 mm | 83.3 in · 2,117 mm | — |
| Length declared | 140.6 in · 3,570 mm | 139.0 in · 3,530 mm | — |
| Width declared | 76.4–88.2 in · 1,940–2,240 mm | 74.8 in · 1,900 mm | differs |
| Ground clearance declared | 15.7 in · 398 mm | — | — |
| Fuel tank declared | 95.1 qt · 90 L | 77.1 qt · 73.0 L | +23% Agroplus 310 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Deutz-Fahr Agroplus 310 sources
- Source: Traktorenlexikon, “Deutz-Fahr Agroplus 310”
Steyr M 963 (a) sources
- Source: Traktorenlexikon, “Steyr M 963”
- Source: Traktorenlexikon, “Case-IH CS52/a”