8 material differences · fewer than 12
Tractor oneDeutz-Fahr Agroplus 310from 2009No measured PTO figureTractor twoJohn Deere 5310 (A)1997–2000No measured PTO figure
Which should you choose?
We will not advise between these two machines, because their unladen weight differs by more than 25% (53%); the drive differs (4WD; Two-wheel or four-wheel drive); they were not built in overlapping years (2009–2009; 1997–2000). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
8 material differences · 4 fields identical or within 5%, which is not counted as material
| Field | Agroplus 310 | 5310 (A) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 62.4 hp | 63.2 hp | — |
| Engine declared | Same 1000.3 WTE3 | John Deere 3.029 T | differs |
| Displacement declared | 3.00 L | 2.93 L | — |
| Maximum torque declared | 180 lb·ft · 244 N·m | 168 lb·ft · 228 N·m | +7% Agroplus 310 |
| Transmission | |||
| Top speed declared | 24.9 mph · 40 km/h | 18.6 mph · 30 km/h | +33% Agroplus 310 |
| Hydraulics & hitch | |||
| Hydraulic centre declared | — | Open centre | — |
| Pump flow declared | — | 12.7 gpm · 48.1 L/min | — |
| Rear PTO speeds declared | 540 rpm / 1000 rpm | 540 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 7,121 lb · 3,230 kg | 4,652 lb · 2,110 kg | +53% Agroplus 310 |
| Wheelbase declared | 82.7 in · 2,100 mm | 80.7 in · 2,050 mm | — |
| Length declared | 140.6 in · 3,570 mm | 139.2 in · 3,535 mm | — |
| Width declared | 76.4–88.2 in · 1,940–2,240 mm | 72.8 in · 1,850 mm | differs |
| Ground clearance declared | 15.7 in · 398 mm | 17.1 in · 435 mm | +9% 5310 (A) |
| Turning radius, braked declared | — | 10.3 ft · 3.15 m | — |
| Fuel tank declared | 95.1 qt · 90 L | 71.9 qt · 68.0 L | +32% Agroplus 310 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Deutz-Fahr Agroplus 310 sources
- Source: Traktorenlexikon, “Deutz-Fahr Agroplus 310”
John Deere 5310 (A) sources
- Source: Traktorenlexikon, “John Deere 5310 (USA)”