7 material differences · fewer than 12
Tractor oneDeutz-Fahr Agrokid 35 A1996–2004No measured PTO figureTractor twoFiat 35-66 (DT)1990–1998No measured PTO figure
Which should you choose?
Read our verdict on the Agrokid 35 A and the 35-66 (DT) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
7 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | Agrokid 35 A | 35-66 (DT) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 34.6 hp | 34.6 hp | — |
| Engine declared | Mitsubishi K4F-D (ab 9/2000: S4L-61 ST) | LOMBARDINI LDW-1503/B2 | differs |
| Displacement declared | — | 1.55 L | — |
| Maximum torque declared | — | 67 lb·ft · 90.9 N·m | — |
| Transmission | |||
| Top speed declared | 16.8 mph · 27 km/h | 18.6 mph · 30 km/h | +11% 35-66 (DT) |
| Clutch declared | Mechanically operated dry SAME double clutch | Dry Valeo or LuK double clutch, type 9/9" | differs |
| Hydraulics & hitch | |||
| Pressure declared | — | 2,872 psi · 198 bar | — |
| Rear PTO speeds declared | 540/1000 rpm | 540 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 2,271–2,723 lb · 1,030–1,235 kg | 2,888 lb · 1,310 kg | differs |
| Maximum permissible mass declared | 5,291 lb · 2,400 kg | — | — |
| Wheelbase declared | 64.2 in · 1,630 mm | 66.9 in · 1,700 mm | — |
| Length declared | 117.5 in · 2,985 mm | 114.6 in · 2,910 mm | — |
| Width declared | 44.1–56.7 in · 1,120–1,440 mm | 54.3–74.0 in · 1,380–1,880 mm | differs |
| Ground clearance declared | 13.6 in · 345 mm | 14.6 in · 370 mm | +7% 35-66 (DT) |
| Turning radius, braked declared | — | 8.4 ft · 2.56 m | — |
| Fuel tank declared | — | 37.0 qt · 35.0 L | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Deutz-Fahr Agrokid 35 A sources
- Source: Traktorenlexikon, “Deutz-Fahr Agrokid 35”
Fiat 35-66 (DT) sources
- Source: Traktorenlexikon, “Fiat 35-66/35-66 DT”