7 material differences · fewer than 12
Tractor oneDeutz-Fahr Agrofarm TB 420from 2010No measured PTO figureTractor twoSteyr 4110 Expert / MY23from 2023No measured PTO figure
Which should you choose?
We will not advise between these two machines, because their unladen weight differs by more than 25% (62%); the drive differs (Two-wheel or four-wheel drive; 4WD); they were not built in overlapping years (2010–2010; 2023–2023). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
7 material differences · 1 fields identical or within 5%, which is not counted as material
| Field | Agrofarm TB 420 | 4110 Expert / MY23 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 98 hp | 99 hp | — |
| Engine declared | Deutz-AG TCD 2012 L04 | — | — |
| Displacement declared | 4.04 L | — | — |
| Maximum torque declared | 280 lb·ft · 380 N·m | — | — |
| Transmission | |||
| Top speed declared | 18.6–24.9 mph · 30–40 km/h | 24.9 mph · 40 km/h | differs |
| Clutch declared | Mechanically operated single-plate dry clutch | — | — |
| Hydraulics & hitch | |||
| Hydraulic control declared | Constant flow | — | — |
| Pump flow declared | 14.8 gpm · 56.0 L/min | 29.1 gpm · 110 L/min | +96% 4110 Expert / MY23 |
| Pressure declared | — | 2,901 psi · 200 bar | — |
| Rear PTO speeds declared | 540/540E/1000/1000E rpm | 540 rpm / 1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 7,496 lb · 3,400 kg | 12,125 lb · 5,500 kg | +62% 4110 Expert / MY23 |
| Wheelbase declared | 92.1 in · 2,340 mm | 98.0 in · 2,490 mm | +6% 4110 Expert / MY23 |
| Length declared | 161.4 in · 4,100 mm | 188.3 in · 4,784 mm | +17% 4110 Expert / MY23 |
| Width declared | 75.4–95.1 in · 1,915–2,415 mm | 87.7 in · 2,228 mm | differs |
| Ground clearance declared | 14.2 in · 360 mm | — | — |
| Turning radius, braked declared | 11.5 ft · 3.50 m | — | — |
| Fuel tank declared | 105.7 qt · 100 L | — | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Deutz-Fahr Agrofarm TB 420 sources
- Source: Traktorenlexikon, “Deutz-Fahr Agrofarm TB 420”
- Source: Traktorenlexikon, “Deutz-Fahr Agrofarm 430”
Steyr 4110 Expert / MY23 sources
- Source: Traktorenlexikon, “Steyr 4110 Expert / MY23”