7 material differences · fewer than 12
Tractor oneDeutz (KHD) F4L 514/41951–1966No measured PTO figureTractor twoHürlimann D-6001951–1954No measured PTO figure
Which should you choose?
We will not advise between these two machines, because their unladen weight differs by more than 25% (26%). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
7 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | F4L 514/4 | D-600 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 58.9 hp | 68.3 hp | +16% D-600 |
| Engine declared | KHD F4L 514 | Hürlimann D-300 | differs |
| Displacement declared | 5.32 L | 5.52 L | — |
| Maximum torque declared | 204 lb·ft · 277 N·m | — | — |
| Transmission | |||
| Top speed declared | 17.3 mph · 27.8 km/h | 12.4 mph · 20 km/h | +39% F4L 514/4 |
| Clutch declared | Pedal operated dry single-plate clutch by Fichtel & Sachs | Pedal operated dry single plate clutch | differs |
| Hydraulics & hitch | |||
| Pressure declared | — | 498 psi · 34 bar | — |
| Rear PTO speeds declared | 540 rpm | 540 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 6,724 lb · 3,050 kg | 8,488 lb · 3,850 kg | +26% D-600 |
| Maximum permissible mass declared | 12,125 lb · 5,500 kg | — | — |
| Wheelbase declared | 96.1 in · 2,440 mm | — | — |
| Length declared | 153.5 in · 3,900 mm | 143.7 in · 3,650 mm | +7% F4L 514/4 |
| Width declared | 75.1 in · 1,907 mm | 74.8 in · 1,900 mm | — |
| Ground clearance declared | 18.5 in · 470 mm | 16.9 in · 430 mm | +9% F4L 514/4 |
| Turning radius, braked declared | 13.1 ft · 4.00 m | 10.7 ft · 3.25 m | +23% F4L 514/4 |
| Fuel tank declared | — | 116.2 qt · 110 L | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Deutz (KHD) F4L 514/4 sources
- Source: Traktorenlexikon, “Deutz F4L 514/4”
- Source: Traktorenlexikon, “Fahr D 55 L”
Hürlimann D-600 sources
- Source: Traktorenlexikon, “Hürlimann D 600”
- Source: Traktorenlexikon, “Hürlimann D 300”