5 material differences · fewer than 12
Tractor oneDeutz (KHD) F3L 514/541954–1956No measured PTO figureTractor twoKramer K 451954–1957No measured PTO figure
Which should you choose?
Read our verdict on the F3L 514/54 and the K 45 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
5 material differences · 6 fields identical or within 5%, which is not counted as material
| Field | F3L 514/54 | K 45 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 44.1 hp | 44.1 hp | — |
| Engine declared | KHD F3L 514 | — | — |
| Displacement declared | 3.99 L | — | — |
| Maximum torque declared | 159 lb·ft · 216 N·m | 159 lb·ft · 216 N·m | — |
| Transmission | |||
| Top speed declared | 12.4 mph · 20.0 km/h | 12.4–17.4 mph · 20–28 km/h | differs |
| Clutch declared | — | Single dry plate clutch by Fichtel & Sachs, type G 30 K | — |
| Hydraulics & hitch | |||
| Pressure declared | 1,707 psi · 118 bar | — | — |
| Rear PTO speeds declared | 577 rpm | 540 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 5,512 lb · 2,500 kg | 5,512 lb · 2,500 kg | — |
| Maximum permissible mass declared | 8,598 lb · 3,900 kg | — | — |
| Wheelbase declared | 81.6 in · 2,073 mm | 78.3 in · 1,990 mm | — |
| Length declared | 134.6 in · 3,420 mm | 129.9 in · 3,300 mm | — |
| Width declared | 69.5 in · 1,765 mm | 75.2 in · 1,910 mm | +8% K 45 |
| Ground clearance declared | 17.1 in · 435 mm | 17.7 in · 450 mm | — |
| Turning radius, braked declared | 9.8 ft · 3.00 m | 8.2 ft · 2.50 m | +20% F3L 514/54 |
| Fuel tank declared | 71.9 qt · 68 L | 58.1 qt · 55 L | +24% F3L 514/54 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Deutz (KHD) F3L 514/54 sources
- Source: Traktorenlexikon, “Deutz F3L 514/54”
- Source: Traktorenlexikon, “Fahr D 45 L”
Kramer K 45 sources
- Source: Traktorenlexikon, “Kramer K 45”