Deutz (KHD) D 2506 or Güldner A 2 BL?

Which should you choose?

On performance, every comparable figure that differs favours the Deutz D 2506: maximum permissible mass. It is also ahead on forward gears.

  • The Deutz D 2506 suits road haulage better on this data: 40% (800 kg / 1,764 lb) more maximum permissible mass.

Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.

What decides it, question by question?

Buyer questions for Deutz (KHD) D 2506 and Güldner A 2 BL, with the call on each
QuestionD 2506A 2 BLCall
Which puts more power through the PTO shaft?16.5 kW (22.1 hp)Traktorenlexikon, “Deutz D 2506”16.9 kW (23 hp)Traktorenlexikon, “Güldner A 2 BL”EvenEven on power at the PTO shaft (both power at the PTO, claimed): the difference is under the 10% threshold for claimed figures, too small to call.
Which turns a litre of fuel into more work at the shaft?No figureNo call on fuel efficiency at the shaft: no figure on record for the D 2506 and the A 2 BL.
Which pulls harder at the drawbar?No figureNo call on drawbar power: no figure on record for the D 2506 and the A 2 BL.
Which pumps more oil for implements?24.5 L/min (6.5 gpm)Traktorenlexikon, “Deutz D 2506”No figureNo call on hydraulic flow: no figure on record for the A 2 BL.
Which lifts more on the three-point hitch?1,560 kg (3,439 lb)Traktorenlexikon, “Deutz D 2506”750 kg (1,653 lb)Traktorenlexikon, “Güldner A 2 BL”EvenNo call on three-point lift: the sources do not state where the lift was measured, so the difference is not a reliable call.
Which is heavier, for traction?1,710 kg (3,770 lb)Traktorenlexikon, “Deutz D 2506”1,460 kg (3,219 lb)Traktorenlexikon, “Güldner A 2 BL”Ahead (a fact, not an advantage)The Deutz D 2506 is 17% heavier (250 kg / 551 lb) than the Güldner A 2 BL (both unladen weight, as stated by the source).
Which may carry more ballast and load?2,800 kg (6,173 lb)Traktorenlexikon, “Deutz D 2506”2,000 kg (4,409 lb)Traktorenlexikon, “Güldner A 2 BL”AheadThe Deutz D 2506 has 40% higher maximum permissible mass (800 kg / 1,764 lb) than the Güldner A 2 BL (both maximum permissible mass, as stated by the source).
Which has the wider choice of gears?8Traktorenlexikon, “Deutz D 2506”6Traktorenlexikon, “Güldner A 2 BL”AheadThe Deutz D 2506 has 33% more forward gears (2 gears) than the Güldner A 2 BL (both forward gears, as stated by the source).
Which offers a creeper range?YesTraktorenlexikon, “Deutz D 2506”YesTraktorenlexikon, “Güldner A 2 BL”EvenEven on a creeper range: every machine offers one.
Which is faster on the road?20 km/h (12.4 mph) to 25 km/h (15.5 mph)Traktorenlexikon, “Deutz D 2506”19.0 km/h (11.8 mph)Traktorenlexikon, “Güldner A 2 BL”EvenEven on top speed (both top speed forward, as stated by the source): the difference is under the 10% threshold, too small to call.
Which offers more PTO speeds?540 rpmTraktorenlexikon, “Deutz D 2506”540 rpmTraktorenlexikon, “Güldner A 2 BL”EvenEven on PTO speeds: the same speeds (540 rpm).
Which PTO runs independently of the ground drive?dependent (stops with the clutch)Traktorenlexikon, “Deutz D 2506”dependent (stops with the clutch)Traktorenlexikon, “Güldner A 2 BL”EvenEven on PTO independence: every PTO is dependent.
Which drives on both axles?2WDTraktorenlexikon, “Deutz D 2506”2WDTraktorenlexikon, “Güldner A 2 BL”EvenEven on drive: all two-wheel drive.
Which is newer, and what about parts?1968–19741959–1960Ahead (a fact, not an advantage)The Deutz D 2506 is newer: production began 9 years later. We hold no parts-availability data, so there is no call on parts.

What does this mean in plain words?

  • The Deutz D 2506 is 17% heavier (250 kg / 551 lb) than the Güldner A 2 BL (both unladen weight, as stated by the source).
  • The Deutz D 2506 has 40% higher maximum permissible mass (800 kg / 1,764 lb) than the Güldner A 2 BL (both maximum permissible mass, as stated by the source).
  • The Deutz D 2506 has 33% more forward gears (2 gears) than the Güldner A 2 BL (both forward gears, as stated by the source).
  • The Deutz D 2506 is newer: production began 9 years later. We hold no parts-availability data, so there is no call on parts.
  • Even on power at the PTO shaft (both power at the PTO, claimed): the difference is under the 10% threshold for claimed figures, too small to call.
  • No call on three-point lift: the sources do not state where the lift was measured, so the difference is not a reliable call.
  • Even on a creeper range: every machine offers one.
  • Even on top speed (both top speed forward, as stated by the source): the difference is under the 10% threshold, too small to call.
  • Even on PTO speeds: the same speeds (540 rpm).
  • Even on PTO independence: every PTO is dependent.
  • Even on drive: all two-wheel drive.
  • No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power and hydraulic flow.

← Every figure for both machines, side by side, with sources