7 material differences · fewer than 12
Tractor oneDeutz (KHD) D 80061970–1978No measured PTO figureTractor twoInternational Harvester Farmall 7661971–1973No measured PTO figure
Which should you choose?
Read our verdict on the D 8006 and the Farmall 766 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
7 material differences · 4 fields identical or within 5%, which is not counted as material
| Field | D 8006 | Farmall 766 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 78.6 hp | 78.9 hp | — |
| Engine declared | KHD F6L 912 | INTERNATIONAL HARVESTER C-291 | differs |
| Displacement declared | 5.65 L | — | — |
| Maximum torque declared | 225 lb·ft · 305 N·m | — | — |
| Transmission | |||
| Top speed declared | 18.0 mph · 29.0 km/h | 18.6 mph · 30 km/h | — |
| Hydraulics & hitch | |||
| Pump flow declared | — | 12.0 gpm · 45.5 L/min | — |
| Pressure declared | 3,046 psi · 210 bar | — | — |
| Rear PTO speeds declared | 540 rpm / 1000 rpm | 540/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 6,636 lb · 3,010 kg | 11,341 lb · 5,144 kg | +71% Farmall 766 |
| Maximum permissible mass declared | 12,787 lb · 5,800 kg | — | — |
| Wheelbase declared | 100.4 in · 2,550 mm | 102.7 in · 2,609 mm | — |
| Length declared | 163.4 in · 4,150 mm | 165.0 in · 4,191 mm | — |
| Width declared | 78.1 in · 1,985 mm | 98.0 in · 2,489 mm | +25% Farmall 766 |
| Ground clearance declared | 20.5 in · 520 mm | 14.0 in · 356 mm | +46% D 8006 |
| Turning radius, braked declared | 13.5 ft · 4.10 m | 9.7 ft · 2.95 m | +39% D 8006 |
| Fuel tank declared | 126.8 qt · 120 L | 147.9 qt · 140.0 L | +17% Farmall 766 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Deutz (KHD) D 8006 sources
- Source: Traktorenlexikon, “Deutz D 8006”
- Source: Traktorenlexikon, “Deutz-Fahr DX 110”
International Harvester Farmall 766 sources
- Source: Traktorenlexikon, “Farmall Farmall 766”
- Source: Traktorenlexikon, “Farmall Farmall 756”