9 material differences · fewer than 12
Tractor oneDeutz (KHD) D 80051965–1967No measured PTO figureTractor twoURSUS C-385 (Ursus)1969–1983No measured PTO figure
Which should you choose?
We will not advise between these two machines, because they were not built in overlapping years (1965–1967; 1969–1983). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
9 material differences · 5 fields identical or within 5%, which is not counted as material
| Field | D 8005 | C-385 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 74 hp | 75.0 hp | — |
| Engine declared | KHD F6L 812 SF | T.S.-MARTIN Z-8001 or Z-7501 | differs |
| Displacement declared | 5.10 L | 4.56 L | +12% D 8005 |
| Maximum torque declared | 197 lb·ft · 267 N·m | 185 lb·ft · 251 N·m | +6% D 8005 |
| Transmission | |||
| Top speed declared | 16.5 mph · 26.5 km/h | 15.5 mph · 25 km/h | +6% D 8005 |
| Clutch declared | Dry double clutch operated by two-stage pedal | Pedal-operated dry ZBROJOVKA-BRNO single-plate clutch type 13" 325 mm disc diameter | differs |
| Hydraulics & hitch | |||
| Hydraulic centre declared | — | Open centre | — |
| Pump flow declared | — | 8.5 gpm · 32.0 L/min | — |
| Pressure declared | — | 2,277 psi · 157 bar | — |
| Rear PTO speeds declared | 540 rpm | 540/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 8,135 lb · 3,690 kg | 7,771 lb · 3,525 kg | — |
| Wheelbase declared | 96.5 in · 2,450 mm | 93.9 in · 2,385 mm | — |
| Length declared | 160.0 in · 4,065 mm | 155.3 in · 3,945 mm | — |
| Width declared | 77.4 in · 1,965 mm | 76.0 in · 1,930 mm | — |
| Ground clearance declared | 23.6 in · 600 mm | 13.8 in · 350 mm | +71% D 8005 |
| Turning radius, braked declared | 13.0 ft · 3.95 m | 9.9 ft · 3.03 m | +30% D 8005 |
| Fuel tank declared | 124.7 qt · 118 L | 95.1 qt · 90.0 L | +31% D 8005 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Deutz (KHD) D 8005 sources
- Source: Traktorenlexikon, “Deutz D 8005”
URSUS C-385 (Ursus) sources
- Source: Traktorenlexikon, “Ursus C-385”
- Source: Traktorenlexikon, “Ursus C-385A”