12 material differences
Tractor oneDeutz (KHD) D 501960–1962No measured PTO figureTractor twoVOLVO-BM T 4301969–1978No measured PTO figure
Which should you choose?
Read our verdict on the D 50 and the T 430 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
12 material differences · 0 fields identical or within 5%, which is not counted as material
| Field | D 50 | T 430 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 45.2 hp | 42.0 hp | +8% D 50 |
| Engine declared | KHD F4L 712 | BM-VOLVO (PERKINS) D-25 (3.152) | differs |
| Displacement declared | 3.40 L | 2.50 L | +36% D 50 |
| Maximum torque declared | 127 lb·ft · 172 N·m | — | — |
| Transmission | |||
| Top speed declared | 12.4 mph · 20 km/h | 18.6 mph · 30 km/h | +50% T 430 |
| Clutch declared | Dry double clutch operated by two-stage pedal | Pedal-operated dry LAYCOCK double clutch | differs |
| Hydraulics & hitch | |||
| Pump flow declared | — | 8.7 gpm · 33.0 L/min | — |
| Pressure declared | 2,134 psi · 147 bar | — | — |
| Rear PTO speeds declared | 590 | 540/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 4,707 lb · 2,135 kg | 5,287 lb · 2,398 kg | +12% T 430 |
| Maximum permissible mass declared | 7,055 lb · 3,200 kg | — | — |
| Wheelbase declared | 87.8 in · 2,230 mm | 82.7 in · 2,101 mm | +6% D 50 |
| Length declared | 142.9 in · 3,630 mm | 129.9 in · 3,300 mm | +10% D 50 |
| Width declared | 73.4 in · 1,865 mm | 69.7 in · 1,770 mm | +5% D 50 |
| Ground clearance declared | 20.3 in · 515 mm | 16.1 in · 410 mm | +26% D 50 |
| Turning radius, braked declared | 11.3 ft · 3.45 m | 10.2 ft · 3.10 m | +11% D 50 |
| Fuel tank declared | 57.1 qt · 54 L | 47.6 qt · 45.0 L | +20% D 50 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Deutz (KHD) D 50 sources
Source
- Source: Traktorenlexikon, “Deutz D 50”
VOLVO-BM T 430 sources
Source
- Source: Traktorenlexikon, “Bolinder-Munktell T 430 Buster”