Deutz (KHD) D 4506 or International Harvester D-440?
Which should you choose?
The data can’t decide this. Power at the PTO shaft cannot be compared: the D 4506 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the D-440 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
- The Deutz D 4506 suits heavy draft work (ploughing, cultivating) better on this data: four-wheel drive.
Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.
What decides it, question by question?
| Question | D 4506 | D-440 | Call |
|---|---|---|---|
| Which puts more power through the PTO shaft? | 29.3 kW (39.3 hp)Traktorenlexikon, “Deutz D 4506” | 29.4 kW (39.4 hp)Traktorenlexikon, “McCormick D-440 Standard” | Not comparableNot comparable on power at the PTO shaft: the D 4506 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the D-440 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft. |
| Which turns a litre of fuel into more work at the shaft? | — | — | No figureNo call on fuel efficiency at the shaft: no figure on record for the D 4506 and the D-440. |
| Which pulls harder at the drawbar? | — | — | No figureNo call on drawbar power: no figure on record for the D 4506 and the D-440. |
| Which pumps more oil for implements? | 27.2 L/min (7.2 gpm)Traktorenlexikon, “Deutz D 4506” | 24.0 L/min (6.3 gpm)Traktorenlexikon, “McCormick D-440 Standard” | AheadThe Deutz D 4506 has 13% more hydraulic flow (3.2 L/min / 0.8 gpm) than the International Harvester D-440 (both pump flow, as stated by the source). |
| Which lifts more on the three-point hitch? | 1,560 kg (3,439 lb)Traktorenlexikon, “Deutz D 4506” | 2,000 kg (4,409 lb)Traktorenlexikon, “McCormick D-440 Standard” | AheadThe International Harvester D-440 has 28% more lift (440 kg / 970 lb) than the Deutz D 4506 (both lift at the hitch ends, as stated by the source). |
| Which is heavier, for traction? | 1,920 kg (4,233 lb)Traktorenlexikon, “Deutz D 4506” | 1,940 kg (4,277 lb)Traktorenlexikon, “McCormick D-440 Standard” | EvenEven on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call. |
| Which may carry more ballast and load? | 3,500 kg (7,716 lb)Traktorenlexikon, “Deutz D 4506” | 3,190 kg (7,033 lb)Traktorenlexikon, “McCormick D-440 Standard” | EvenEven on maximum permissible mass (both maximum permissible mass, as stated by the source): the difference is under the 10% threshold, too small to call. |
| Which has the wider choice of gears? | 8Traktorenlexikon, “Deutz D 4506” | 8Traktorenlexikon, “McCormick D-440 Standard” | EvenEven on forward gears (both forward gears, as stated by the source): the difference is under the 25% threshold, too small to call. |
| Which offers a creeper range? | — | — | No figureNo call on a creeper range: not stated for the D 4506 and the D-440. |
| Which is faster on the road? | 20 km/h (12.4 mph)Traktorenlexikon, “Deutz D 4506” | 20 km/h (12.4 mph)Traktorenlexikon, “McCormick D-440 Standard” | EvenEven on top speed (both top speed forward, as stated by the source): the difference is under the 10% threshold, too small to call. |
| Which offers more PTO speeds? | 540 rpmTraktorenlexikon, “Deutz D 4506” | 540 rpmTraktorenlexikon, “McCormick D-440 Standard” | EvenEven on PTO speeds: the same speeds (540 rpm). |
| Which PTO runs independently of the ground drive? | — | independentTraktorenlexikon, “McCormick D-440 Standard” | No figureNo call on PTO independence: not stated for the D 4506. |
| Which drives on both axles? | 2WD / 4WDTraktorenlexikon, “Deutz D 4506” | 2WDTraktorenlexikon, “McCormick D-440 Standard” | AheadThe Deutz D 4506 is available with four-wheel drive; the International Harvester D-440 is two-wheel drive (as stated by the sources). |
| Which is newer, and what about parts? | 1972–1980 | 1958–1959 | Ahead (a fact, not an advantage)The Deutz D 4506 is newer: production began 14 years later. We hold no parts-availability data, so there is no call on parts. |
What does this mean in plain words?
- The Deutz D 4506 has 13% more hydraulic flow (3.2 L/min / 0.8 gpm) than the International Harvester D-440 (both pump flow, as stated by the source).
- The International Harvester D-440 has 28% more lift (440 kg / 970 lb) than the Deutz D 4506 (both lift at the hitch ends, as stated by the source).
- The Deutz D 4506 is available with four-wheel drive; the International Harvester D-440 is two-wheel drive (as stated by the sources).
- The Deutz D 4506 is newer: production began 14 years later. We hold no parts-availability data, so there is no call on parts.
- Even on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call.
- Even on maximum permissible mass (both maximum permissible mass, as stated by the source): the difference is under the 10% threshold, too small to call.
- Even on forward gears (both forward gears, as stated by the source): the difference is under the 25% threshold, too small to call.
- Even on top speed (both top speed forward, as stated by the source): the difference is under the 10% threshold, too small to call.
- Even on PTO speeds: the same speeds (540 rpm).
- Not comparable on power at the PTO shaft: the D 4506 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the D-440 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
- No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, a creeper range and PTO independence.
← Every figure for both machines, side by side, with sources