6 material differences · fewer than 12
Tractor oneDeutz (KHD) D 45051965–1967No measured PTO figureTractor twoFord 2000 Dexta (A)1968–1975No measured PTO figure
Which should you choose?
We will not advise between these two machines, because the drive differs (2WD; Two-wheel or four-wheel drive); they were not built in overlapping years (1965–1967; 1968–1975). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
6 material differences · 5 fields identical or within 5%, which is not counted as material
| Field | D 4505 | 2000 Dexta (A) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 39.3 hp | 39.3 hp | — |
| Engine declared | KHD F3L 812 | — | — |
| Displacement declared | 2.55 L | — | — |
| Maximum torque declared | 95 lb·ft · 129 N·m | 112 lb·ft · 152 N·m | +18% 2000 Dexta (A) |
| Transmission | |||
| Top speed declared | 12.4–15.5 mph · 20–25 km/h | 12.4–18.6 mph · 20–30 km/h | differs |
| Hydraulics & hitch | |||
| Pressure declared | 2,538 psi · 175 bar | — | — |
| Rear PTO speeds declared | 540 rpm | 540 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 4,233 lb · 1,920 kg | 4,123 lb · 1,870 kg | — |
| Maximum permissible mass declared | 7,055 lb · 3,200 kg | — | — |
| Wheelbase declared | 78.5 in · 1,995 mm | 76.0 in · 1,930 mm | — |
| Length declared | 134.4 in · 3,415 mm | 126.4 in · 3,210 mm | +6% D 4505 |
| Width declared | 63.4 in · 1,610 mm | 63.8 in · 1,620 mm | — |
| Ground clearance declared | 16.3 in · 415 mm | 19.7 in · 500 mm | +20% 2000 Dexta (A) |
| Turning radius, braked declared | 10.8 ft · 3.30 m | 9.8 ft · 3.00 m | +10% D 4505 |
| Fuel tank declared | 67.6 qt · 64 L | 51.8 qt · 49 L | +31% D 4505 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Deutz (KHD) D 4505 sources
- Source: Traktorenlexikon, “Deutz D 4505”
Ford 2000 Dexta (A) sources
- Source: Traktorenlexikon, “Ford 2000 S”