7 material differences · fewer than 12
Tractor oneDeutz (KHD) D 25.11960No measured PTO figureTractor twoGüldner AW1962No measured PTO figure
Which should you choose?
We will not advise between these two machines, because they were not built in overlapping years (1960–1960; 1962–1962). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
7 material differences · 8 fields identical or within 5%, which is not counted as material
| Field | D 25.1 | AW | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 19.6 hp | 19.7 hp | — |
| Engine declared | KHD F2L 712 | Güldner 2 DNS | differs |
| Displacement declared | 1.70 L | 1.31 L | +30% D 25.1 |
| Maximum torque declared | 64 lb·ft · 86 N·m | 54 lb·ft · 74 N·m | +16% D 25.1 |
| Transmission | |||
| Top speed declared | 12.4 mph · 20 km/h | 12.4 mph · 20 km/h | — |
| Clutch declared | — | pedal operated dry single clutch from Fichtel & Sachs | — |
| Hydraulics & hitch | |||
| Pressure declared | 2,134 psi · 147 bar | 2,134 psi · 147 bar | — |
| Rear PTO speeds declared | 257/540 rpm | 540 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 2,921 lb · 1,325 kg | 2,954 lb · 1,340 kg | — |
| Maximum permissible mass declared | 5,071 lb · 2,300 kg | 4,409 lb · 2,000 kg | +15% D 25.1 |
| Wheelbase declared | 74.8 in · 1,900 mm | 72.8 in · 1,850 mm | — |
| Length declared | 115.7 in · 2,940 mm | 121.3 in · 3,080 mm | — |
| Width declared | 62.6 in · 1,590 mm | 59.8 in · 1,520 mm | — |
| Ground clearance declared | 16.9 in · 430 mm | 14.2 in · 360 mm | +19% D 25.1 |
| Turning radius, braked declared | 8.5 ft · 2.60 m | 8.7 ft · 2.65 m | — |
| Fuel tank declared | 31.7 qt · 30 L | 37.0 qt · 35 L | +17% AW |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Deutz (KHD) D 25.1 sources
- Source: Traktorenlexikon, “Deutz D 25.1”
- Source: Traktorenlexikon, “Deutz D 25.1 S”
Güldner AW sources
- Source: Traktorenlexikon, “Güldner A W”
- Source: Traktorenlexikon, “Fahr D 131 W”