Deutz (KHD) D 13006 A or Steyr 8140 (a)?

Which should you choose?

The data can’t decide this. Power at the PTO shaft cannot be compared: the D 13006 A has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 8140 (a) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.

  • The Deutz D 13006A suits loader and hydraulic implement work better on this data: 91% (2,000 kg / 4,409 lb) more three-point lift.

Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.

What decides it, question by question?

Buyer questions for Deutz (KHD) D 13006 A and Steyr 8140 (a), with the call on each
QuestionD 13006 A8140 (a)Call
Which puts more power through the PTO shaft?88 kW (118 hp)Traktorenlexikon, “Deutz D 13006”88.3 kW (118.4 hp)Traktorenlexikon, “Steyr 8140”Not comparableNot comparable on power at the PTO shaft: the D 13006 A has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 8140 (a) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
Which turns a litre of fuel into more work at the shaft?——No figureNo call on fuel efficiency at the shaft: no figure on record for the D 13006 A and the 8140 (a).
Which pulls harder at the drawbar?——No figureNo call on drawbar power: no figure on record for the D 13006 A and the 8140 (a).
Which pumps more oil for implements?—40.9 L/min (10.8 gpm)Traktorenlexikon, “Steyr 8140”No figureNo call on hydraulic flow: no figure on record for the D 13006 A.
Which lifts more on the three-point hitch?4,200 kg (9,259 lb) to 5,000 kg (11,023 lb)Traktorenlexikon, “Deutz D 13006”2,200 kg (4,850 lb)Traktorenlexikon, “Steyr 8140”AheadThe Deutz D 13006A has 91% more lift (2,000 kg / 4,409 lb) than the Steyr 8140 (a) (both lift at the hitch ends, as stated by the source).
Which is heavier, for traction?4,760 kg (10,494 lb)Traktorenlexikon, “Deutz D 13006”4,650 kg (10,251 lb)Traktorenlexikon, “Steyr 8140”EvenEven on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call.
Which may carry more ballast and load?——No figureNo call on maximum permissible mass: no figure on record for the D 13006 A and the 8140 (a).
Which has the wider choice of gears?—12Traktorenlexikon, “Steyr 8140”No figureNo call on forward gears: no figure on record for the D 13006 A.
Which offers a creeper range?YesTraktorenlexikon, “Deutz D 13006”—No figureNo call on a creeper range: not stated for the 8140 (a).
Which is faster on the road?30 km/h (18.6 mph)Traktorenlexikon, “Deutz D 13006”30 km/h (18.6 mph)Traktorenlexikon, “Steyr 8140”EvenEven on top speed (both top speed forward, as stated by the source): the difference is under the 10% threshold, too small to call.
Which offers more PTO speeds?1000 rpmTraktorenlexikon, “Deutz D 13006”540/1000 rpmTraktorenlexikon, “Steyr 8140”AheadThe Steyr 8140 (a) offers 540 rpm at the PTO, which the Deutz D 13006A does not (as stated by the sources).
Which PTO runs independently of the ground drive?independentTraktorenlexikon, “Deutz D 13006”independentTraktorenlexikon, “Steyr 8140”EvenEven on PTO independence: every PTO is independent.
Which drives on both axles?4WDTraktorenlexikon, “Deutz D 13006”Two-wheel or four-wheel driveTraktorenlexikon, “Steyr 8140”EvenEven on drive: every machine is available with four-wheel drive.
Which is newer, and what about parts?1972–19781977–1982Ahead (a fact, not an advantage)The Steyr 8140 (a) is newer: production began 5 years later. We hold no parts-availability data, so there is no call on parts.

What does this mean in plain words?

  • The Deutz D 13006A has 91% more lift (2,000 kg / 4,409 lb) than the Steyr 8140 (a) (both lift at the hitch ends, as stated by the source).
  • The Steyr 8140 (a) offers 540 rpm at the PTO, which the Deutz D 13006A does not (as stated by the sources).
  • The Steyr 8140 (a) is newer: production began 5 years later. We hold no parts-availability data, so there is no call on parts.
  • Even on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call.
  • Even on top speed (both top speed forward, as stated by the source): the difference is under the 10% threshold, too small to call.
  • Even on PTO independence: every PTO is independent.
  • Even on drive: every machine is available with four-wheel drive.
  • Not comparable on power at the PTO shaft: the D 13006 A has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 8140 (a) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
  • No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, hydraulic flow, maximum permissible mass, forward gears and a creeper range.

← Every figure for both machines, side by side, with sources