6 material differences · fewer than 12
Tractor oneDeutz (KHD) D 12006 A1971No measured PTO figureTractor twoJohn Deere 50101962–1966No measured PTO figure
Which should you choose?
We will not advise between these two machines, because their unladen weight differs by more than 25% (30%); the drive differs (4WD; 2WD); they were not built in overlapping years (1971–1971; 1962–1966). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
6 material differences · 5 fields identical or within 5%, which is not counted as material
| Field | D 12006 A | 5010 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 118 hp | 121 hp | — |
| Engine declared | KHD BF6L 912 | Deere 531 CID | differs |
| Displacement declared | 5.65 L | 8.70 L | +54% 5010 |
| Maximum torque declared | 304 lb·ft · 412 N·m | 339 lb·ft · 459 N·m | +11% 5010 |
| Transmission | |||
| Top speed declared | 18.0 mph · 29 km/h | 18.6 mph · 30 km/h | — |
| Clutch declared | — | Single-plate dry clutch | — |
| Hydraulics & hitch | |||
| Pressure declared | 2,538 psi · 175 bar | — | — |
| Rear PTO speeds declared | 1000 rpm | 1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 10,274 lb · 4,660 kg | 13,400 lb · 6,078 kg | +30% 5010 |
| Maximum permissible mass declared | 16,535 lb · 7,500 kg | — | — |
| Wheelbase declared | 101.6 in · 2,580 mm | 103.9 in · 2,640 mm | — |
| Length declared | 166.1 in · 4,220 mm | 172.0 in · 4,370 mm | — |
| Width declared | 88.6 in · 2,250 mm | 95.7 in · 2,430 mm | +8% 5010 |
| Ground clearance declared | 16.7 in · 425 mm | — | — |
| Turning radius, braked declared | 16.4 ft · 5.00 m | — | — |
| Fuel tank declared | 126.8 qt · 120 L | 191.3 qt · 181 L | +51% 5010 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Deutz (KHD) D 12006 A sources
- Source: Traktorenlexikon, “Deutz D 12006”
- Source: Traktorenlexikon, “Deutz D 13006”
John Deere 5010 sources
- Source: Traktorenlexikon, “John Deere 5010”
- Source: Traktorenlexikon, “John Deere 5020”