8 material differences · fewer than 12
Tractor oneDEUTZ-ALLIS DX 4.701984–1986No measured PTO figureTractor twoInternational Harvester 9551977–1982No measured PTO figure
Which should you choose?
Read our verdict on the DX 4.70 and the 955 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
8 material differences · 4 fields identical or within 5%, which is not counted as material
| Field | DX 4.70 | 955 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 88.4 hp | 88.4 hp | — |
| Engine declared | KHD BF4L 913 | IH D-310 (D-358) | differs |
| Displacement declared | 4.09 L | 5.07 L | +24% 955 |
| Maximum torque declared | 236 lb·ft · 320 N·m | — | — |
| Transmission | |||
| Top speed declared | 18.6 mph · 30 km/h | 18.6 mph · 30 km/h | — |
| Clutch declared | — | Fichtel & Sachs dry double clutch, type DUT 310-310/310 | — |
| Hydraulics & hitch | |||
| Pump flow declared | 12.9 gpm · 48.8 L/min | 11.3 gpm · 42.6 L/min | +15% DX 4.70 |
| Pressure declared | 3,481 psi · 240 bar | — | — |
| Rear PTO speeds declared | 540/1000 rpm | 540/1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 8,488 lb · 3,850 kg | 9,017–10,108 lb · 4,090–4,585 kg | differs |
| Maximum permissible mass declared | 12,787 lb · 5,800 kg | — | — |
| Wheelbase declared | 91.7 in · 2,330 mm | 102.0–103.5 in · 2,590–2,630 mm | differs |
| Length declared | 164.2 in · 4,170 mm | 165.1–166.5 in · 4,194–4,229 mm | — |
| Width declared | 90.7 in · 2,304 mm | 80.7 in · 2,049 mm | +12% DX 4.70 |
| Ground clearance declared | 20.9 in · 530 mm | 15.0–22.1 in · 382–562 mm | differs |
| Turning radius, braked declared | — | 14.4–15.3 ft · 4.40–4.67 m | — |
| Fuel tank declared | 132.1 qt · 125.0 L | 147.9 qt · 140 L | +12% 955 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
DEUTZ-ALLIS DX 4.70 sources
Source
- Source: Traktorenlexikon, “Deutz-Allis DX 4.70”
- Source: Traktorenlexikon, “Deutz-Fahr AgroStar 4.78”
International Harvester 955 sources
Source
- Source: Traktorenlexikon, “IHC 955”