6 material differences · fewer than 12
Tractor oneDEUTZ-ALLIS 80701985–1988No measured PTO figureTractor twoSchlüter Super 1700 LS (high speed)1993No measured PTO figure
Which should you choose?
We will not advise between these two machines, because the drive differs (Two-wheel or four-wheel drive; 4WD); they were not built in overlapping years (1985–1988; 1993–1993). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
6 material differences · 5 fields identical or within 5%, which is not counted as material
| Field | 8070 | Super 1700 LS (high speed) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 169.6 hp | 170.0 hp | — |
| Engine declared | ALLIS-CHALMERS 670 TI | MAN D0 826 LE 503 | differs |
| Displacement declared | 6.98 L | 6.87 L | — |
| Transmission | |||
| Top speed declared | 18.6 mph · 30 km/h | 24.9–31.1 mph · 40–50 km/h | differs |
| Clutch declared | Electro-hydraulically operated wet multi-plate clutch | — | — |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Closed centre | — | — |
| Pump flow declared | 22.0 gpm · 83.3 L/min | — | — |
| Pressure declared | 3,771 psi · 260 bar | — | — |
| Rear PTO speeds declared | 1000 rpm | 674/1126 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 16,850 lb · 7,643 kg | 14,110 lb · 6,400 kg | +19% 8070 |
| Wheelbase declared | 106.0 in · 2,692 mm | 110.6 in · 2,810 mm | — |
| Length declared | 187.0 in · 4,750 mm | 187.4 in · 4,760 mm | — |
| Width declared | 95.5 in · 2,426 mm | 98.4 in · 2,500 mm | — |
| Ground clearance declared | 22.0 in · 559 mm | — | — |
| Turning radius, braked declared | 13.3 ft · 4.06 m | 15.4 ft · 4.70 m | +16% Super 1700 LS (high speed) |
| Fuel tank declared | 239.9 qt · 227.0 L | 327.6 qt · 310 L | +37% Super 1700 LS (high speed) |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
DEUTZ-ALLIS 8070 sources
- Source: Traktorenlexikon, “Deutz-Allis 8070”
- Source: Traktorenlexikon, “Deutz-Allis 8050”
Schlüter Super 1700 LS (high speed) sources
- Source: Traktorenlexikon, “Schlüter Super 1700 LS / TVL-LS”
- Source: Traktorenlexikon, “Schlüter Super 1600 TVL /TVL-LS”