DEUTZ-ALLIS 8070 or J.I. Case 2394 (DT)?
Which should you choose?
The data can’t decide this. Power at the PTO shaft cannot be compared: the 8070 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 2394 (DT) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
- The DEUTZ-ALLIS 8070 suits heavy draft work (ploughing, cultivating) better on this data: four-wheel drive.
Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.
What decides it, question by question?
| Question | 8070 | 2394 (DT) | Call |
|---|---|---|---|
| Which puts more power through the PTO shaft? | 126.5 kW (169.6 hp)Traktorenlexikon, “Deutz-Allis 8070” | 125.8 kW (168.7 hp)Traktorenlexikon, “Case 2394” | Not comparableNot comparable on power at the PTO shaft: the 8070 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 2394 (DT) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft. |
| Which turns a litre of fuel into more work at the shaft? | — | — | No figureNo call on fuel efficiency at the shaft: no figure on record for the 8070 and the 2394 (DT). |
| Which pulls harder at the drawbar? | — | — | No figureNo call on drawbar power: no figure on record for the 8070 and the 2394 (DT). |
| Which pumps more oil for implements? | 83.3 L/min (22.0 gpm)Traktorenlexikon, “Deutz-Allis 8070” | — | No figureNo call on hydraulic flow: no figure on record for the 2394 (DT). |
| Which lifts more on the three-point hitch? | 3,720 kg (8,201 lb)Traktorenlexikon, “Deutz-Allis 8070” | 6,100 kg (13,448 lb)Traktorenlexikon, “Case 2394” | Not comparableNot comparable on three-point lift: the 8070: lift 610 mm behind the hitch ends, as stated by the source (Traktorenlexikon, “Deutz-Allis 8070”); the 2394 (DT): lift at the hitch ends, as stated by the source (Traktorenlexikon, “Case 2394”) — not the same quantity, basis and condition. |
| Which is heavier, for traction? | 7,643 kg (16,850 lb)Traktorenlexikon, “Deutz-Allis 8070” | 7,365 kg (16,237 lb)Traktorenlexikon, “Case 2394” | EvenEven on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call. |
| Which may carry more ballast and load? | — | — | No figureNo call on maximum permissible mass: no figure on record for the 8070 and the 2394 (DT). |
| Which has the wider choice of gears? | 12 to 20Traktorenlexikon, “Deutz-Allis 8070” | 12 to 24Traktorenlexikon, “Case 2394” | EvenEven on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap. |
| Which offers a creeper range? | — | — | No figureNo call on a creeper range: not stated for the 8070 and the 2394 (DT). |
| Which is faster on the road? | 30 km/h (18.6 mph)Traktorenlexikon, “Deutz-Allis 8070” | 30 km/h (18.6 mph)Traktorenlexikon, “Case 2394” | EvenEven on top speed (both top speed forward, as stated by the source): the difference is under the 10% threshold, too small to call. |
| Which offers more PTO speeds? | 1000 rpmTraktorenlexikon, “Deutz-Allis 8070” | 1000 rpmTraktorenlexikon, “Case 2394” | EvenEven on PTO speeds: the same speeds (1000 rpm). |
| Which PTO runs independently of the ground drive? | independentTraktorenlexikon, “Deutz-Allis 8070” | independentTraktorenlexikon, “Case 2394” | EvenEven on PTO independence: every PTO is independent. |
| Which drives on both axles? | Two-wheel or four-wheel driveTraktorenlexikon, “Deutz-Allis 8070” | 2WDTraktorenlexikon, “Case 2394” | AheadThe DEUTZ-ALLIS 8070 is available with four-wheel drive; the J.I. Case 2394 (DT) is two-wheel drive (as stated by the sources). |
| Which is newer, and what about parts? | 1985–1988 | 1984–1985 | EvenSame era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts. |
What does this mean in plain words?
- The DEUTZ-ALLIS 8070 is available with four-wheel drive; the J.I. Case 2394 (DT) is two-wheel drive (as stated by the sources).
- Even on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call.
- Even on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap.
- Even on top speed (both top speed forward, as stated by the source): the difference is under the 10% threshold, too small to call.
- Even on PTO speeds: the same speeds (1000 rpm).
- Even on PTO independence: every PTO is independent.
- Same era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts.
- Not comparable on power at the PTO shaft: the 8070 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 2394 (DT) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
- Not comparable on three-point lift: the 8070: lift 610 mm behind the hitch ends, as stated by the source (Traktorenlexikon, “Deutz-Allis 8070”); the 2394 (DT): lift at the hitch ends, as stated by the source (Traktorenlexikon, “Case 2394”) — not the same quantity, basis and condition.
- No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, hydraulic flow, maximum permissible mass and a creeper range.
← Every figure for both machines, side by side, with sources