7 material differences · fewer than 12
Tractor oneDEUTZ-ALLIS 80501985–1988No measured PTO figureTractor twoFord 87301989–1994No measured PTO figure
Which should you choose?
Read our verdict on the 8050 and the 8730 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
7 material differences · 6 fields identical or within 5%, which is not counted as material
| Field | 8050 | 8730 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 151.9 hp | 151.9 hp | — |
| Engine declared | ALLIS-CHALMERS 670 TI | Ford 401 | differs |
| Displacement declared | 6.98 L | 6.58 L | +6% 8050 |
| Maximum torque declared | — | 387 lb·ft · 525 N·m | — |
| Transmission | |||
| Top speed declared | 18.6 mph · 30 km/h | 18.6 mph · 30 km/h | — |
| Clutch declared | electrohydraulically operated wet multi-plate clutch | — | — |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Closed centre | — | — |
| Pump flow declared | 22.0 gpm · 83.3 L/min | 28.3 gpm · 107.1 L/min | +29% 8730 |
| Pressure declared | 3,771 psi · 260 bar | 2,045 psi · 141 bar | +84% 8050 |
| Rear PTO speeds declared | 540/1000 rpm | 540/1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 15,304 lb · 6,942 kg | 14,859 lb · 6,740 kg | — |
| Maximum permissible mass declared | — | 25,133 lb · 11,400 kg | — |
| Wheelbase declared | 106.0 in · 2,692 mm | 110.8 in · 2,814 mm | — |
| Length declared | 187.0 in · 4,750 mm | 193.4 in · 4,913 mm | — |
| Width declared | 95.5 in · 2,426 mm | 104.5–137.4 in · 2,655–3,490 mm | differs |
| Ground clearance declared | 22.0 in · 559 mm | 18.2 in · 462 mm | +21% 8050 |
| Turning radius, braked declared | 12.1 ft · 3.68 m | — | — |
| Fuel tank declared | 239.9 qt · 227.0 L | 400.5 qt · 379.0 L | +67% 8730 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
DEUTZ-ALLIS 8050 sources
Source
- Source: Traktorenlexikon, “Deutz-Allis 8050”
Ford 8730 sources
Source
- Source: Traktorenlexikon, “Ford 8730”