9 material differences · fewer than 12
Tractor oneDEUTZ-ALLIS 71201986–1989No measured PTO figureTractor twoSAME Buffalo 130 (DT)1978–1982No measured PTO figure
Which should you choose?
Read our verdict on the 7120 and the Buffalo 130 (DT) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
9 material differences · 4 fields identical or within 5%, which is not counted as material
| Field | 7120 | Buffalo 130 (DT) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 122.3 hp | 122.3 hp | — |
| Engine declared | K.H.D. BF6L 913 T | SAME DA 1056 P | differs |
| Displacement declared | 6.13 L | 6.23 L | — |
| Maximum torque declared | — | 295 lb·ft · 400 N·m | — |
| Transmission | |||
| Top speed declared | 18.6 mph · 30 km/h | 15.5 mph · 25 km/h | +20% 7120 |
| Clutch declared | dry single clutch | Pedal operated dry BORG & BECK single plate clutch | differs |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Open centre | — | — |
| Pump flow declared | 24.0 gpm · 90.8 L/min | 9.2 gpm · 35.0 L/min | +159% 7120 |
| Pressure declared | 3,481 psi · 240 bar | — | — |
| Rear PTO speeds declared | 540/1000 rpm | 540/1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 11,244 lb · 5,100 kg | 9,480 lb · 4,300 kg | +19% 7120 |
| Wheelbase declared | 105.8 in · 2,687 mm | 104.7 in · 2,660 mm | — |
| Length declared | 179.5 in · 4,560 mm | 170.1 in · 4,320 mm | +6% 7120 |
| Width declared | 93.3 in · 2,370 mm | 85.4–113.0 in · 2,170–2,870 mm | differs |
| Ground clearance declared | 24.4 in · 620 mm | 20.9 in · 530 mm | +17% 7120 |
| Turning radius, braked declared | — | 13.5 ft · 4.10 m | — |
| Fuel tank declared | 159.6 qt · 151.0 L | 147.9 qt · 140.0 L | +8% 7120 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
DEUTZ-ALLIS 7120 sources
- Source: Traktorenlexikon, “Deutz-Allis 7120”
SAME Buffalo 130 (DT) sources
- Source: Traktorenlexikon, “SAME Buffalo 130”
- Source: Traktorenlexikon, “SAME Drago 120”