9 material differences · fewer than 12
Tractor oneDEUTZ-ALLIS 62401986–1990No measured PTO figureTractor twoFiat 45-66 V (DT/V)1985–1992No measured PTO figure
Which should you choose?
Read our verdict on the 6240 and the 45-66 V (DT/V) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
9 material differences · 4 fields identical or within 5%, which is not counted as material
| Field | 6240 | 45-66 V (DT/V) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 44.0 hp | 44.4 hp | — |
| Engine declared | KHD F3L 912 | FIAT-IVECO 8035.06.220 or 320 | differs |
| Displacement declared | 2.83 L | 2.71 L | — |
| Maximum torque declared | 123 lb·ft · 167 N·m | 107 lb·ft · 144.6 N·m | +15% 6240 |
| Transmission | |||
| Top speed declared | 18.6 mph · 30 km/h | 18.6 mph · 30 km/h | — |
| Clutch declared | Independent dry double clutch | Dry Valeo or LuK double clutch | differs |
| Hydraulics & hitch | |||
| Pump flow declared | 7.7 gpm · 29.1 L/min | — | — |
| Pressure declared | 3,481 psi · 240 bar | — | — |
| Rear PTO speeds declared | 540/1000 rpm | 540/1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 5,776 lb · 2,620 kg | 3,373 lb · 1,530 kg | +71% 6240 |
| Maximum permissible mass declared | 8,818 lb · 4,000 kg | — | — |
| Wheelbase declared | 79.2 in · 2,012 mm | 72.6 in · 1,845 mm | +9% 6240 |
| Length declared | 137.4 in · 3,490 mm | 113.6 in · 2,885 mm | +21% 6240 |
| Width declared | 82.3 in · 2,090 mm | 53.5 in · 1,360 mm | +54% 6240 |
| Ground clearance declared | 16.1 in · 410 mm | 12.8 in · 325 mm | +26% 6240 |
| Fuel tank declared | 79.3 qt · 75.0 L | 52.8 qt · 50.0 L | +50% 6240 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
DEUTZ-ALLIS 6240 sources
- Source: Traktorenlexikon, “Deutz-Allis 6240”
- Source: Traktorenlexikon, “Deutz D 4006 P”
Fiat 45-66 V (DT/V) sources
- Source: Traktorenlexikon, “Fiat 45-66 V/45-66 V/DT”