9 material differences · fewer than 12

Tractor oneDEUTZ-ALLIS 62401986–1990No measured PTO figureTractor twoFendt Farmer 2 Wfrom 1971No measured PTO figure

Which should you choose?

We will not advise between these two machines, because their unladen weight differs by more than 25% (75%); the drive differs (Two-wheel or four-wheel drive; 4WD); they were not built in overlapping years (1986–1990; 1971–1971). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.

Field by field

9 material differences · 3 fields identical or within 5%, which is not counted as material

DEUTZ-ALLIS 6240 and Fendt Farmer 2 W, field by field
Field6240Farmer 2 WGap
Engine
Engine power, claimed claimed44.0 hp44.1 hp—
Engine declaredKHD F3L 912MWM D 325-3differs
Displacement declared2.83 L2.55 L+11% 6240
Maximum torque declared123 lb·ft · 167 N·m——
Transmission
Top speed declared18.6 mph · 30 km/h12.2–15.5 mph · 19.6–25.0 km/hdiffers
Clutch declaredIndependent dry double clutchTornado duplex clutch by Fichtel & Sachsdiffers
Hydraulics & hitch
Pump flow declared7.7 gpm · 29.1 L/min8.0 gpm · 30.5 L/min—
Pressure declared3,481 psi · 240 bar——
Rear PTO speeds declared540/1000 rpm540/1000 rpm—
Weight & dimensions
Unladen weight declared5,776 lb · 2,620 kg3,307 lb · 1,500 kg+75% 6240
Maximum permissible mass declared8,818 lb · 4,000 kg——
Wheelbase declared79.2 in · 2,012 mm69.9 in · 1,775 mm+13% 6240
Length declared137.4 in · 3,490 mm108.3 in · 2,750 mm+27% 6240
Width declared82.3 in · 2,090 mm37.4 in · 950 mm+120% 6240
Ground clearance declared16.1 in · 410 mm9.1 in · 230 mm+78% 6240
Turning radius, braked declared—4.9 ft · 1.50 m—
Fuel tank declared79.3 qt · 75.0 L——

Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.

DEUTZ-ALLIS 6240 sources

Source
  • Source: Traktorenlexikon, “Deutz-Allis 6240”
  • Source: Traktorenlexikon, “Deutz D 4006 P”

Fendt Farmer 2 W sources

Source
  • Source: Traktorenlexikon, “Fendt Farmer 2 W”
  • Source: Traktorenlexikon, “Renault 60 R7253”