9 material differences · fewer than 12
Tractor oneDEUTZ-ALLIS 62401986–1990No measured PTO figureTractor twoFendt F 345 GT1984–1996No measured PTO figure
Which should you choose?
Read our verdict on the 6240 and the F 345 GT → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
9 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | 6240 | F 345 GT | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 44.0 hp | 44.1 hp | — |
| Engine declared | KHD F3L 912 | KHD-Unterflurmotor F3 L 912 H | differs |
| Displacement declared | 2.83 L | 2.83 L | — |
| Maximum torque declared | 123 lb·ft · 167 N·m | 128 lb·ft · 173 N·m | — |
| Transmission | |||
| Top speed declared | 18.6 mph · 30 km/h | 24.9 mph · 40 km/h | +33% F 345 GT |
| Clutch declared | Independent dry double clutch | — | — |
| Hydraulics & hitch | |||
| Pump flow declared | 7.7 gpm · 29.1 L/min | — | — |
| Pressure declared | 3,481 psi · 240 bar | — | — |
| Rear PTO speeds declared | 540/1000 rpm | 540/750/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 5,776 lb · 2,620 kg | 6,669 lb · 3,025 kg | +15% F 345 GT |
| Maximum permissible mass declared | 8,818 lb · 4,000 kg | 11,905 lb · 5,400 kg | +35% F 345 GT |
| Wheelbase declared | 79.2 in · 2,012 mm | 118.1 in · 3,000 mm | +49% F 345 GT |
| Length declared | 137.4 in · 3,490 mm | 177.2 in · 4,500 mm | +29% F 345 GT |
| Width declared | 82.3 in · 2,090 mm | 68.1 in · 1,730 mm | +21% 6240 |
| Ground clearance declared | 16.1 in · 410 mm | 18.7 in · 475 mm | +16% F 345 GT |
| Turning radius, braked declared | — | 12.5 ft · 3.80 m | — |
| Fuel tank declared | 79.3 qt · 75.0 L | — | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
DEUTZ-ALLIS 6240 sources
- Source: Traktorenlexikon, “Deutz-Allis 6240”
- Source: Traktorenlexikon, “Deutz D 4006 P”
Fendt F 345 GT sources
- Source: Traktorenlexikon, “Fendt F 345 GT”