DEUTZ-ALLIS 6060 or Fiat 65-66 (DT)?
Which should you choose?
The data can’t decide this. Power at the PTO shaft cannot be compared: the 6060 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 65-66 (DT) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
- The Fiat 65-66 (DT) suits road haulage better on this data: 20% (5.0 km/h / 3.1 mph) more top speed.
Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.
What decides it, question by question?
| Question | 6060 | 65-66 (DT) | Call |
|---|---|---|---|
| Which puts more power through the PTO shaft? | 47.8 kW (64.1 hp)Traktorenlexikon, “Deutz-Allis 6060” | 47.8 kW (64.1 hp)Traktorenlexikon, “Fiat 65-66/65-66 DT” | Not comparableNot comparable on power at the PTO shaft: the 6060 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 65-66 (DT) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft. |
| Which turns a litre of fuel into more work at the shaft? | — | — | No figureNo call on fuel efficiency at the shaft: no figure on record for the 6060 and the 65-66 (DT). |
| Which pulls harder at the drawbar? | — | — | No figureNo call on drawbar power: no figure on record for the 6060 and the 65-66 (DT). |
| Which pumps more oil for implements? | 71.9 L/min (19.0 gpm)Traktorenlexikon, “Deutz-Allis 6060” | 32.8 L/min (8.7 gpm)Traktorenlexikon, “Fiat 65-66/65-66 DT” | AheadThe DEUTZ-ALLIS 6060 has 119% more hydraulic flow (39.1 L/min / 10.3 gpm) than the Fiat 65-66 (DT) (both pump flow, as stated by the source). |
| Which lifts more on the three-point hitch? | 1,588 kg (3,501 lb)Traktorenlexikon, “Deutz-Allis 6060” | 2,260 kg (4,982 lb)Traktorenlexikon, “Fiat 65-66/65-66 DT” | AheadThe Fiat 65-66 (DT) has 42% more lift (672 kg / 1,482 lb) than the DEUTZ-ALLIS 6060 (both lift 610 mm behind the hitch ends, as stated by the source). |
| Which is heavier, for traction? | 2,585 kg (5,699 lb)Traktorenlexikon, “Deutz-Allis 6060” | 2,510 kg (5,534 lb)Traktorenlexikon, “Fiat 65-66/65-66 DT” | EvenEven on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call. |
| Which may carry more ballast and load? | — | 4,200 kg (9,259 lb)Traktorenlexikon, “Fiat 65-66/65-66 DT” | No figureNo call on maximum permissible mass: no figure on record for the 6060. |
| Which has the wider choice of gears? | 8Traktorenlexikon, “Deutz-Allis 6060” | 12 to 20Traktorenlexikon, “Fiat 65-66/65-66 DT” | AheadThe Fiat 65-66 (DT) has 50% more forward gears (4 gears) than the DEUTZ-ALLIS 6060 (both forward gears, as stated by the source). |
| Which offers a creeper range? | — | — | No figureNo call on a creeper range: not stated for the 6060 and the 65-66 (DT). |
| Which is faster on the road? | 25 km/h (15.5 mph)Traktorenlexikon, “Deutz-Allis 6060” | 30 km/h (18.6 mph) to 40 km/h (24.9 mph)Traktorenlexikon, “Fiat 65-66/65-66 DT” | AheadThe Fiat 65-66 (DT) has 20% more top speed (5.0 km/h / 3.1 mph) than the DEUTZ-ALLIS 6060 (both top speed forward, as stated by the source). |
| Which offers more PTO speeds? | 540 rpmTraktorenlexikon, “Deutz-Allis 6060” | 540/1000 rpmTraktorenlexikon, “Fiat 65-66/65-66 DT” | AheadThe Fiat 65-66 (DT) offers 1000 rpm at the PTO, which the DEUTZ-ALLIS 6060 does not (as stated by the sources). |
| Which PTO runs independently of the ground drive? | independentTraktorenlexikon, “Deutz-Allis 6060” | independentTraktorenlexikon, “Fiat 65-66/65-66 DT” | EvenEven on PTO independence: every PTO is independent. |
| Which drives on both axles? | Two-wheel or four-wheel driveTraktorenlexikon, “Deutz-Allis 6060” | Two-wheel or four-wheel driveTraktorenlexikon, “Fiat 65-66/65-66 DT” | EvenEven on drive: every machine is available with four-wheel drive. |
| Which is newer, and what about parts? | 1985–1988 | 1985–1991 | EvenSame era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts. |
What does this mean in plain words?
- The DEUTZ-ALLIS 6060 has 119% more hydraulic flow (39.1 L/min / 10.3 gpm) than the Fiat 65-66 (DT) (both pump flow, as stated by the source).
- The Fiat 65-66 (DT) has 42% more lift (672 kg / 1,482 lb) than the DEUTZ-ALLIS 6060 (both lift 610 mm behind the hitch ends, as stated by the source).
- The Fiat 65-66 (DT) has 50% more forward gears (4 gears) than the DEUTZ-ALLIS 6060 (both forward gears, as stated by the source).
- The Fiat 65-66 (DT) has 20% more top speed (5.0 km/h / 3.1 mph) than the DEUTZ-ALLIS 6060 (both top speed forward, as stated by the source).
- The Fiat 65-66 (DT) offers 1000 rpm at the PTO, which the DEUTZ-ALLIS 6060 does not (as stated by the sources).
- Even on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call.
- Even on PTO independence: every PTO is independent.
- Even on drive: every machine is available with four-wheel drive.
- Same era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts.
- Not comparable on power at the PTO shaft: the 6060 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 65-66 (DT) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
- No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, maximum permissible mass and a creeper range.
← Every figure for both machines, side by side, with sources