6 material differences · fewer than 12
Tractor oneClaas Ares 697 ATZ2005–2007No measured PTO figureTractor twoFendt Favorit 714 Variofrom 1998No measured PTO figure
Which should you choose?
We will not advise between these two machines, because they were not built in overlapping years (2005–2007; 1998–1998). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
6 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | Ares 697 ATZ | Favorit 714 Vario | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 138 hp | 138 hp | — |
| Engine declared | — | Deutz BF6M 2013 C | — |
| Displacement declared | — | 5.70 L | — |
| Maximum torque declared | 436 lb·ft · 591 N·m | — | — |
| Transmission | |||
| Top speed declared | 24.9 mph · 40 km/h | 31.1 mph · 50 km/h | +25% Favorit 714 Vario |
| Clutch declared | — | Multi-disc clutch | — |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Closed centre | — | — |
| Hydraulic control declared | — | Load sensing | — |
| Pump flow declared | — | 29.3 gpm · 111.0 L/min | — |
| Pressure declared | 2,901 psi · 200 bar | 2,683 psi · 185 bar | +8% Ares 697 ATZ |
| Rear PTO speeds declared | 540/1000 rpm | 540/750/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 12,412 lb · 5,630 kg | 12,677–14,451 lb · 5,750–6,555 kg | differs |
| Maximum permissible mass declared | 20,393 lb · 9,250 kg | 24,251 lb · 11,000 kg | +19% Favorit 714 Vario |
| Wheelbase declared | 111.0 in · 2,820 mm | 106.3 in · 2,700 mm | — |
| Length declared | 203.1 in · 5,160 mm | 182.7–183.2 in · 4,640–4,653 mm | differs |
| Width declared | 100.4 in · 2,550 mm | 100.4–102.0 in · 2,550–2,590 mm | — |
| Ground clearance declared | — | 22.7 in · 576 mm | — |
| Turning radius, braked declared | — | 16.1 ft · 4.90 m | — |
| Fuel tank declared | 264.2 qt · 250 L | — | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Claas Ares 697 ATZ sources
- Source: Traktorenlexikon, “Claas Ares 697 ATZ”
- Source: OECD test report 2295, 2005
Fendt Favorit 714 Vario sources
- Source: Traktorenlexikon, “Fendt Favorit 714 Vario”